audiophony Mio-Sub 8150b Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} audiophony Mio-Sub 8150b. audiophony Mio-Sub 8150b 4 pagina's.

Pagina afdrukken
2 - Main characteristics
• High-efficiency self-powered subwoofer
• Up to 4 satellites simultaneously
• Steel protective grille
3 - Description
4
5
1
Power input socket
Allows you to connect your amplification module to an
electrical outlet via the supplied power cord. Please
make sure the voltage delivered is compatible with your
built-in amplification module (230V) before connecting it.
2
Fuse
Protects the built-in amplification module.
If need to replace it, please make sure the new one has
the exact same characteristics.
3
Power button
Allows you to activate/deactivate the built-in amplifier.
4
Indicator LEDs
-Power: Lights up to indicate the amplification module
is activated.
-Signal: Lights up to indicate a signal has been
detected via the module inputs.
-Clip: Lights up to indicate the signal level exceeds 0dB.
In this situation, please use the volume
control knob to decrease the volume
so this LED only lights up occasionally.
You will then benefit from a better sound
quality and avoid serious damages to your
subwoofer.
5
Volume control knob
Allows you to adjust the main volume (satellites and
basses). Please make sure the CLIP LED only lights red
occasionally to guarantee an optimal sound quality.
POWER
SIGNAL
CLIP
VOLUME
PHASE
BASS
180°
0°
0
10
0
10
L
6 7
• XLR/Jack and RCA inputs
• Independent LF volume control
OUTPUT 1
L
INPUT
L
R
OUTPUT 2
8
9
10
6
PHASE Button
Activate this function if basses are not powerful enough.
In most cases, weak basses are due to a poor satellites
positioning with the subwoofer.
7
BASS Control knob
Allows you to adjust basses amplification level.
8
Left and right inputs via COMBO sockets
The COMBO socket allows you to either connect a male
XLR or male mono/stereo Jack plug.
9
Left and right inputs via RCA sockets
Unbalanced inputs.
10
Output terminals
Connect here your speakers cable by making sure you
respect the polarities.
Speakers connected to these terminals must not have
an impedance lower than 8 Ohms.
When connecting cables, please make sure output
1 and output 2 do not come into contact. Please try
tinning your cables before connecting them in order to
guarantee an optimal lifespan to your cables.
You can connect up to 4 x 8 Ohms satellites to a single
subwoofer. Two satellites via OUTPUT 1 and two via
OUTPUT 2.
AUDIOPHONY PUBLIC ADDRESS
POWER
AC 230V 50/60Hz
R
R
1
2
3
Page 3