Consonance Reference150 Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Consonance Reference150. Consonance Reference150 5 pagina's. Consonance reference150 integrated amplifier

Pagina afdrukken

SOUND ADVICE

The Consonance Reference150 Integrated Amplifier is easy to connect and operate and requires no prior

technical knowledge. However, to get the most out of the amplifier's superior sound and music quality, we have

provided a brief description of the connections and use of the amplifier in order to provide a total music

experience.

We recommend keeping this user guide for future reference.

GENERAL USE

The amplifier is switched on with the button ① in the left of the front panel. A flashing " -- -- --" blue light in the

display ② indicates that power is switched on. By pushing the same button one more time the power is switched

off.

When power is switched on, the blue indicator located behind the left side of display will light and keep flashing

slightly. After about 30 seconds, the blue indicator will stop flashing and indicate normal tube filament operation.

Note: It takes about 1 minute for the 6H30 tube to reach its normal operating point, and only slight sonic

improvement will be noticed after 5 minutes.

the left knob ③ is the channel selector with selections:INPUT1(" IN1"), INPUT2(" IN2"), INPUT3(" IN3"),

BALANCED INPUT("BAL") , and the right knob ④ is the volume control.

Note: all the function of input selecting and volume control could be displayed on the screen, which will

go automatically dim 20 seconds later. When the mute function is switched on, the present volume level

will keep flashing on the screen to indicates mute mode is on.

Avoid connecting input cables or selecting inputs with the source selector switch if the volume setting of the

amplifier is not fully turned down and the speakers are connected. A transient signal might then arise, which can

damage the speakers. The amplifier will not be harmed, but to avoid overloading the speakers, the volume should

be turned fully down or the mute function should be switched on when connecting and disconnecting cables.

Note: The volume will be turned fully down automatically when the amplifier is switched off and re-

switched on for the same reason.

After the amplifier is switched on, there is a delay of about 30 seconds for the music signal to reach the speaker

outputs. The amplifier is protected against short-circuiting of the speaker terminals , but we still recommend

turning off the amplifier when connecting and disconnecting signal and speaker cables.