Audioplex TVC 600 Installatiehandleiding

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Audioplex TVC 600. Audioplex TVC 600 2 pagina's.

Pagina afdrukken

Attenuator type:

Switch:

Connectors:

Power rating:

Transformers:

Dimensions:

Installation must be made by qualified service personnel, and must meet all local codes.

The connectors on this attenuator are large binding posts, allowing a variety of different gauge wire to be

used. Use the wiring diagram on the back of this instruction sheet, following the guide lines below.

Make connections by stripping the wire insulation back about 3/16". Twist any loose strands tightly.

Insert the wires from the amplifier into the INPUT openings of the connector, hot to hot and ground to

ground, and tighten binding post. Check for stray wire strands that might cause a short circuit.

Similarly, connect speaker wires to the control OUTPUT openings and tighten binding post.

Install control in its operating location. Suggestion: Leave control 3 or 4 positions CCW from maximum

before firing-up the system for the first time to avoid "blasting" the speakers, while still having enough

sound to observe operation.

Your AUDIOPLEX TECHNOLOGY(tm) Stereo Speaker Volume Control is covered by a life time

warranty against any defects in workmanship and materials. Any defects will be remedied without charge for

labor or parts.

Damage incurred by shipping or accident is not considered to be a defect, and not covered by this

warranty. AUDIOPLEX TECHNOLOGY(tm) is not responsible for defective operation caused by abuse or by

modification or service by any unauthorized person or agency.

The product must be properly installed and operated according to instructions for the warranty to apply.

Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY(tm). The product must be returned

expenses prepaid, with written authorization from the company. The product must be shipped with the proof of

purchase and in the original carton and packing material to avoid damage.

This warranty gives you specific legal rights. You may have other rights which vary from state to state.

TECHNOLOGY

Tapped auto transformer.

12 position rotary, make-before-break contacts, low torque specifications for

smooth feel.

Large binding posts.

250 Watts RMS continuous, 35Hz-20 KHz, 600 Watts peak audio.

Tri-filar wound for flat response and minimum phase shift, grain oriented, -30 dB

in 12 steps;

Step 12: full on

Step 11: -3 dB

Step 10: -3 dB

Step 9: -2 dB

17"W x 3.5"H x 6"D.

Step 8: -2 dB

Step 7: -1 dB

Step 6: -3 dB

Step 5: -3 dB

Step 4: -3 dB

Step 3: -3 dB

Step 2: -3 dB

Step 1: OFF