Constellation audio Inspiration PREAMP 1.0 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16 pagina's.
Ook voor Constellation audio Inspiration PREAMP 1.0: Gebruikershandleiding (16 pagina's)

Pagina afdrukken

Before you install the amplifier

Unpacking

At 55 pounds each, the Inspiration MONO 1.0 and

Inspiration STEREO 1.0 are too heavy for one person to lift

safely. Two strong people are required to lift each amplifier

and to move it from place to place.

Likewise, do not place these amplifiers on surfaces that

cannot safely support their weight. Lightweight furniture

and equipment racks should not be used to support these

amplifiers.

Lift each amplifier by hooking your fingers under the side

edges, as indicated by the arrows in the photos at right. It's

a good idea to wear soft gloves to protect your fingers and

help avoid fingerprints on the amplifier.

AC connection

For best performance, each amplifier should be plugged into its own dedicated 15- or 20-amp AC outlet, with

no other component but the amplifier connected to that AC circuit.

It is especially desirable to provide a dedicated AC output if the amplifier is used with a speaker that has

impedance dips down into the 2- or 3-ohm range at certain frequencies, a high-level signal at these

frequencies can draw potential peaks well over 1,000 watts per channel with the Inspiration MONO 1.0.

While it may be tempting to plug two Inspiration MONO 1.0s into a single AC circuit, we caution against it,

especially if you have 15-amp AC circuits. A single 15-amp circuit provides only 1,800 watts of power, which

isn't sufficient to allow two Inspiration MONO 1.0s to reach their peak output capability with low-impedance

speakers. Not only will sound quality suffer, your listening sessions might be interrupted often when the

Inspiration MONO 1.0s' considerable power draw trips your home's circuit breaker.

Do not plug the amplifier(s) into a power strip or AC line conditioner—few such products are designed to

handle the current that these amps can pull.

When you connect or disconnect the AC cord, always grasp it by the plug, not by the cord itself. Pulling the

plug out by the cord can damage the cord, the AC socket, and/or the amplifier.