Contacta HLD7 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Contacta HLD7. Contacta HLD7 20 pagina's. Hearing loop driver
Ook voor Contacta HLD7: Gebruikershandleiding (16 pagina's)

Pagina afdrukken
Contacta HLD7 Gebruikershandleiding

Loop Configurations / Set Up

PLEASE NOTE: The loop cable must be connected before powering up
the driver. Upon power up the loop is automatically analysed and set
up. If no loop is connected the status light will be solid red. To RESET
unplug the driver and wait 60 seconds minimum after all lights go out.
Perimeter Loop or Primary Driver Setup*
(Assumes unit is properly connected and loop has continuity)
1. Power up the driver and once the loop analysis (indicated by the
flashing LED sequence) is complete, confirm or select the correct
driver type (Perimeter or Primary). Instructions on changing driver type
on page 13.
2. Enter the "Adjustment Mode" by pressing the MIC (+ and - )
buttons simultaneously until the red status light flashes.
3. While in "Adjustment Mode" (red status light flashing) confirm that
the MIC, LINE and DRIVE levels are set to their minimum level by
individually holding in the - button of each for a few seconds.
4. Connect the input signal to the LINE input unless you are directly
connecting a microphone. If testing with our Test Signal Generator
(TSG), connect to the HLD7's LINE input.
5. For either input signal (in adjustment mode) increase the
appropriate input level by pressing the - button until the first yellow
LED illuminates (this will be solid if using a sine wave) or occasionally
flash if used on music or speech sources.
6. Bring the DRIVE level up by pressing the DRIVE + button until the
required level is reached.
Assumes unit is properly connected and loop has continuity.
*
10
contacta HLD9
MIC
LINE
CLIP
CLIP
PERIMETER
ACTIVE
ACTIVE
PRIMARY
PHTM
LOW SIG
SECONDARY
MIC
CLIP
ACTIVE
PHTM
MIC
CLIP
ACTIVE
MIC
LINE
PHTM
CLIP
ACTIVE
PHTM
2.5
5
7.5
10
DRIVE
STATUS
POWER
2.5
contacta HLD9
LINE
CLIP
PERIMETER
ACTIVE
PRIMARY
LOW SIG
SECONDARY
MIC
LINE
CLIP
CLIP
ACTIVE
ACTIVE
PHTM
LOW SIG
contac
LINE
2.5
contacta HLD9
CLIP
PERIME
ACTIVE
PRIMA
LOW SIG
SECON
CLIP
PERIMETER
ACTIVE
PRIMARY
LOW SIG
SECONDARY
5
7.5
10
DRIVE
STATUS
POWER
2.5
5
7.5
contacta HLD9
DRIVE
PERIMETER
STATUS
PRIMARY
POWER
SECONDARY