Audiotel International 2-197-869 Bedieningshandleiding - Pagina 9

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Audiotel International 2-197-869. Audiotel International 2-197-869 16 pagina's. Non-linear junction detector

Pagina afdrukken

SuperBroom Plus TA – Operating Manual

- M

RACTICAL

ONSIDERATIONS

Although metal junctions usually result in stronger third

harmonic and weaker second harmonic return signals

a particular metallic junction may give an 'electronic

Component' like return.

Metallic junctions are often very sensitive to vibration and

this vibration can be heard if LISTEN is selected (also select

'2nd') and the area tapped with a rubber faced hammer or

other object that will not cause material damage.

A box of paper clips is a good example of a metallic target

and experimentation will demonstrate the value of LISTEN.

ETAL

UNCTIONS

At any time during or after the above sequence attaching

the unit to an external power supply via the external AC/DC

Adaptor will start to recharge the SuperBroom battery pack.

WARNING Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended

by the manufacturer. Dispose of batteries according to the

manufacturer's instructions.

HARGING

SuperBroom is designed to automatically enter a dormant

state when power is applied via the external AC/DC adaptor,

(positive centre), SuperBroom input is protected against,

reverse-polarity and over-current.

The AC/DC Adaptor supplied will work with AC voltages

from 100 to 240VAC.

The Charger socket is located on the right-hand panel of

your SuperBroom. It is recommended that the SuperBroom is

left to charge for 6 hours to ensure a full charge.

When connected to the AC/DC Adpator the Battery Charge

Status LED on the front display panel is illuminated Red.

When the battery is fully charged the front panel LED

changes to Green.

Note When your SuperBroom is fi rst unpacked the internal battery

pack may not be fully charged.

Caution Only use manufacturers recommended external AC/DC

adaptor.

AUDIOTEL INTERNATIONAL Ltd – Issue 3.1 (09/2004 )

Setting Up

ATTERY