Duratax NITRO DEMON Montage- en bedieningshandleiding - Pagina 12

Blader online of download pdf Montage- en bedieningshandleiding voor {categorie_naam} Duratax NITRO DEMON. Duratax NITRO DEMON 20 pagina's.

❏

34. Screw the plastic ball cup onto the throttle

linkage wire. Install one rod collar onto the linkage rod,

then slide on the throttle linkage spring. Insert the

throttle linkage through the rod connector as shown.

Note: Do not tighten the set screw in the rod collar

down, adjustments will be made later.

❏

35. Snap the ball cup onto the throttle arm on the

carburetor. Install a second rod collar onto the throttle

linkage so that it fits against the rod connector. Note:

Do not tighten the set screw in the rod collar, the

linkage will be adjusted later.

❏

36. Slide a 1/4" piece of fuel tubing over each of the

brake linkage rods. Then install a rod collar onto each

of the two rods. Note: Do not tighten the set screw

in the rod collars, the linkage will be adjusted later.

AIR FILTER AND FUEL TUBING

INSTALLATION

❏

37. Locate the fuel tubing included with the kit. Cut

a 6" (150mm) piece to go from the fuel tank to the

carburetor and a 4" (100mm) piece to go from the fuel

tank to the pressure nipple on the tuned pipe.

❏

38.Install one end of the 6" (150mm) piece of fuel

tubing onto the rotatable nipple on the rear of the fuel

tank and the other end onto the nipple on the carburetor.

❏

39.Install one end of the 4" (100mm) piece of fuel

tubing onto the nipple next to the fuel tank lid and the

other end on the nipple on the muffler.

❏

40. Assemble the air filter. Slide the large rubber O-ring

around the threads of the outer housing. The O-ring will

help seal the air filter housing together.