Contax TLA30 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Contax TLA30. Contax TLA30 11 pagina's. Modern classic slr series

Pagina afdrukken

You can also

Download a Copy

(9) Flash Mode Selector The selector is used to switch to any of the three modes, TTL Auto, Normal Auto and Manual flash. Be

sure to set the selector precisely on the click-stop position.

(10) Auto Check Lamp (For Normal Auto Flash Mode Only) In the Normal Auto flash mode, this lamp is used to indicate whether

subject was within effective flash range. After the exposure, it will signal a green after-flash for about three seconds if your subject

was within effective flash range; otherwise, the absence of such a signal indicates that the subject was not within the correct flash

range. The Auto Check Lamp is not designed to operate in the TTL Auto or the Manual flash modes.

(11) Flash-Ready Lamp/Test Button The Flash-Ready Lamp lights red when the flash unit is ready to flash. This control also

doubles as a test button for test flashing.

Basic Electronic Flash Control

TTL AUTO Flash Operation

When using the TLA30 with a Contax camera incorporating direct TTL auto flash metering system, merely set the camera to the

auto mode and the flash unit to the "TTL" mode. When the flash unit is ready to flash, the camera automatically switches over to the

camera's synch speed and two LEDs inside the viewfinder indicate that both the flash unit and camera are ready to flash.

(2) Set the Flash Mode Selector to "TTL". Slide the flash mode selector to the "TTL" click-stop position.

Note: In the case of the Contax 137 MA/MD Quartz, make a functional check of the viewfinder LED display by lightly depressing the

shutter release button part way down.

(6) Exposure Computer Dial By setting the ASA/ISO film speed scale to

the speed of the film in use, it is possible to read out the following

exposure data: (a) In the TTL Auto mode, the flash range for the aperture

in effect-, (b) In the Normal Auto mode, the coverage aperture readings

and the flash ranges for the given apertures,- and (c) In the Manual Flash

mode, the correct aperture reading for the selected flash-to-subject

distance.

(7) Auto Flash Range Guide In the TTL Auto and Normal Auto modes,

the Auto Flash Range Guide shows the effective flash range for the

coverage aperture, Align the white band's extreme right (Thick white

band) with the coverage aperture reading on the Exposure Computer

Dial. The white band indicates the effective flash range for the given

aperture.

(8) Normal Auto Flash Mode Index Marks

and green index marks indicate the coverage apertures to use in the

Normal Auto mode.

of the PDF file (516k) for your future reference.

with Contax TLA 30 >

(1) Set the Camera on the Auto Mode. The camera is set on

the auto mode by turning the shutter control dial to "A".

(3) Set the Film Speed Scale. Rotate and set the Exposure Computer

Dial by aligning the white -,L" index mark with the correct ASA/ISO film

speed for the film in use. To rotate the dial, exert fingertip pressure

against the two little round-shaped projections placed opposite each other

on the dial, making sure to set the scale squarely on a click-stop.

(4) Check the LED Indicators Inside the Viewfinder. Turn the flash

unit's power switch to "ON", and then press the camera's exposure check

button to make a functional check of the LED display inside the viewfinder.

When the flash unit has recycled, the camera switches to its flash synch

speed (1/60 sec. for the RTS II Quartz) and a " " mark in the viewfinder

lights to indicate that the flash unit and camera are ready to flash. The

shutter speed display flashes the "60" mark at the same time.

(Red

and Green) The red