DAPAudio PA-306 Handmatig - Pagina 10

Blader online of download pdf Handmatig voor {categorie_naam} DAPAudio PA-306. DAPAudio PA-306 15 pagina's.

Operation

Remove all packing materials from the PA-306. Check that all foam and plastic padding is removed.

Secure the equipment into a 19" rack. Connect all cables.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 115V specification product on 230V power, or vice versa.

Before powering up the first time, make sure the AC-selector switch is set to the proper voltage.

Damage caused by connecting the amplifier to improper AC voltage is not covered by any warranty.

NOTE: Always turn off and disconnect the amplifier from mains voltage before making audio

connections. Also, as an extra precaution, have the attenuators turned down during

Use the XLR input connectors on the rear to supply audio signals to your DAP Audio PA-Series amplifier.

The connectors accept balanced and unbalanced audio connections. (The PA- Series amplifiers are

configured standard with "Pin 2 hot" on XLR inputs. For more Information, see the section on Connection

cables on page 10.

Speakers are connected using terminal connectors. See the examples below and following page.

You can use as many speakers as you want, as long as the total impedance matches the amplifiers

output.

Example 1: using the 4Ω output with two 8Ω speakers.

Example 2: using the 4Ω output with four 4Ω speakers

power-up.

Fig. 3

Fig. 4