DAPAudio DCP-24 Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} DAPAudio DCP-24. DAPAudio DCP-24 20 pagina's.

Pagina afdrukken

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.

Install this device on a flat surface, not bend or curved.

Do not supply power before

Make sure to power-up your DCP-24before your power amplifiers are switched on in order to avoid loud

transients, which could damage your speakers or annoy your audience.

System test

After connecting all cables, you should run a system test. Press all Mute-buttons in order to mute all

outputs. Activate the HF-outputs first. In case of wrong cabling, High Frequency (HF) audio signals will

come out of bass-speakers that cannot be harmed this way. Vice versa, the Low Frequency (LF) audio

signals would destroy your HF-speakers.

Input setup

Press the Channel Up button to select the channel you wish to edit. In the example below, input

channel A is selected.

Adjust the gain by dialing the jogwheel (8). Push the Item up (2) button to proceed with the next item. In

our example the Lowpass filter.

Adjust by dialing the jogwheel (8). You can switch the lowpass filter off by dialing the jogwheel (8)

clockwise until the frequency passes 20kHz. Click the jogwheel (8) to change the filter type.

Select the type by dialing the jogwheel (8). You can choose from: But(terworth) 6dB, Bes(sel) 6dB,

But(terworth) 12dB, Bes(sel) 12dB, L(inkwitz) R(iley)12dB, But(terworth) 18dB, Bes(sel) 18dB, But(terworth)

24dB and Bes(sel) 24dB. Once selected the correct filter type, click the jogwheel (8) to return to the

lowpass filter frequency (for (re)adjusting) or push the Item up (2) button to proceed with the next item, in

our example, the Highpass filter.

Adjust the highpass frequency by dialing the jogwheel (8). You can switch the highpass filter off by

dialing the jogwheel (8) counterclockwise until the frequency passes 20Hz. Click the jogwheel (8) to

select a filter type.

all components of the system are

InA

11.75dB

11,75dB_________

InA

_________

freq: 19600hz

11,75dB_________

_________

InA

Type: but 6db

11,75dB_________

_________

InA

Freq:

11,75dB_________

_________

set up and connected properly.

Gain

LowPass

HighPass

Off