Duratuf KL3 Montagehandleiding - Pagina 5

Blader online of download pdf Montagehandleiding voor {categorie_naam} Duratuf KL3. Duratuf KL3 16 pagina's. Kiwi series

Note:

For sheds with the Raised Floor Modification option the studs will be 1.780m long to allow the Wall Sheets to pro-

trude 20mm below the Bottom Plate. Refer to Raised Floor Modification section (Page 15).

Note:

If fitting a window in the Back Wall, there will be no centre stud on that side. Instead nail in a full length Nog (3.290) using

Window Studs (.883) to get correct height. Position one Window Stud centrally beneath the Nog and nail in place. Further

window studs and Nogs are fitted after the cladding is on.

Step 1: End Walls: Select one 1.210m End Base Plate

(Green), one 1.210m End Top Plate (Red) and two

Studs (Yellow). Lay out Plates and two Studs on a flat

surface and nail together using two 75mm nails per

join. Position 1.120m Nog .883m down from Top Plate

and nail in place. Repeat with other end wall.

Step 2: Select one 3.380m Base Plate (Green) one 3.380m

Top Plate (Red). Stand up End frame with the Stud

side of the frame on the ground. Nail 3.380m plates to

frame using two nails per join. Ensure Red joins to Red

and Green joins to Green. Repeat with other end

frame. Nail in back wall centre stud using 1.622m Nogs

to get correct position. Position Nogs .883m down from

Top Plate and nail in place.

Step 3: Select one 3.380m Base Plate (Green) and the Ridge

Beam (90 x 45). Nail in place. Ensure Red joins to Red.

Step 4: Carefully roll the frame over so that the Ridge Beam

and Base Plate (Green) are on the ground. Select two

studs (Yellow) and one .785m Nog and one 1.622m

Nog. Nail in Studs using the nogs to get the correct

position top and bottom. Position nogs .883m down

from the Top Plate and nail in place.

Step 5: Carefully roll frame over onto its base. If fitting a Kiwi

Floor, fit Floor Joists now. Place the joist centrally and

nail in place using three 75mm nails per end.

KL3 TIMBER FRAME