Duratuf PL46 Montagehandleiding - Pagina 13

Blader online of download pdf Montagehandleiding voor {categorie_naam} Duratuf PL46. Duratuf PL46 16 pagina's.

Pagina afdrukken

ROOF ASSEMBLY

SELECT:

3 x 2.200 m Roof Sheets

1 x 1.555 m Spouting

2 x 2.200 m Barges

16 x 50mm Roofing Screws

24 x Rivets

4 x 50mm Clouts

STEP 1:

• Ensure Shed is sitting level and square.

• Lay Roof Sheets on the Top Plates.

• Rivet sheets together at overlaps with 2 x rivets per join.

STEP 2:

• Position the Roof Sheets with front overhang of 130mm at each

end (fig. 1).

• Using 4 x 50mm Clouts, predrill and nail the Roof Sheets to the Top

Plates through the ribs, at each corner, ensuring ribs on the Roof

Sheets line up with ribs on the Wall Sheets (fig.2).

STEP 3:

• Ensure the Front and Back Top Plates are straight.

• Screw the roof sheets to the front & back Top Plates, using 1 x

Roofing Screw per rib. (fig.2).

STEP 4:

• Place barge flashings on roof at end of shed ensuring the diagonal

trimmed end is at the front. (See diagram on pg 5)

• Rivet the Barge Flashings to the roof and the side wall, using four

rivets on top of barge and four into the side (fig.3).

STEP 5:

• Place spouting in position and rivet to Barge Flashings at each end

and rivet to roof sheets (1 rivet per 1 sheet) (fig.4).

IMPORTANT

Use 50mm Clouts only on outside ribs covered by Barge flashings. Predrill

holes using a 3.5mm drill bit. Use Roofing Screws on all other ribs.

IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR ROOF PANEL

Assemble as below, making sure that the Clear Roof Sheets overlap the stand-

ard roof sheets on both sides. Pre drill and fasten with the 50mm roofing

screws provided. Ensuring screws are not overtightened as this can damage

the seals and cause the shed to leak.

TOP PLATE

BACK WALL

BOTTOM PLATE

SIDE

WALL

130mm

Pan

Barge

X 4

Spouting

SIDE

WALL

FRONT

WALL

130mm

fig.1

Rib

fig.2

X 4

fig.3

fig.4