Duratuf SG2020 Montagehandleiding - Pagina 11

Blader online of download pdf Montagehandleiding voor {categorie_naam} Duratuf SG2020. Duratuf SG2020 16 pagina's.

Pagina afdrukken

ASSEMBLE FRONT PANEL

SELECT:

2 x 1.850 Wall Sheets

1 x 2.020 Top Plate (Red)

1 x 2.020 Bottom Plate (Green)

2 x 1.850 Door Jamb Flashings

28 x 30mm Galv Clouts

17 x Rivets

STEP 1:

• Lay out 1 x Top Plate and 1 x Bottom Plate on a flat

surface as shown

NOTE:

The Doorway is standard at 530mm from left-hand end.

To shift the doorway to the right-hand side of the front

wall, simply measure 530mm from the right-hand end.

STEP 2:

• Using 2 x 30mm clouts, nail the Door Jamb Flashing flush with

the top of the Top Plate at the correct measurement as shown

in plan view. Pre drill holes using a 3.5mm drill bit

• Check the distance between the top and bottom plates then use

a further 2 x 30mm clouts to nail the Door Jamb Flashings to

the bottom Plate. Pre drill holes.

STEP 3:

• Place 2 x Wall Sheets on timber, ensuring wall sheets fit un-

derneath door jamb flashings.

• Ensure that the top of the sheets are flush with the top of the

Top Plate and that the sides of the wall sheets overhang the

Top Plate by 15mm as shown. Nail wall sheets to Top Plate

(two clouts per pan)

• Nail the wall sheets to the Bottom Plate making sure that the

Plates are the correct distance apart and that the sides of the

wall sheets overhang the Bottom Plate by 15mm.

• Drill & rivet Door Jamb Flashings to wall sheets using four

rivets equally spaced on each side.

NOTE:

Door can be hinged on either side.

STEP 4:

• Place the door on the panel (In open position, approx

20mm below top of top plate). Using two rivets, rivet the top

and bottom hinges to the Door Jamb Flashing, ensuring

door closes properly.

• Fit remaining rivets.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

1811mm

15mm

TOP PLATE

BOTTOM PLATE

Plan View

TOP PLATE

DOOR OPENING

530mm

960mm

15mm

1811mm

TOP

PLATE

NAIL

DOOR

JAMB

15mm