Duratuf Sentry SG3030 Montagehandleiding - Pagina 9

Blader online of download pdf Montagehandleiding voor {categorie_naam} Duratuf Sentry SG3030. Duratuf Sentry SG3030 16 pagina's.

Pagina afdrukken

ASSEMBLE SIDE PANELS

SELECT:

4 x 1.880 m Gable Wall Sheets (Angled)

4 x 1.940 m Gable Wall Sheets (Angled)

4 x 2.000 m Gable Wall Sheets (Angled)

2 x 3.020 m Top Plates (Red)

2 x 3.020 m Bottom Plates (Green)

144 x 30mm Galv Clouts

20 x Rivets

STEP 1:

• Lay out 1 x Top plate and 1 x Bottom plate on a flat surface as shown

(corner cut-outs to face outwards).

Bottom plates are critical to ensure wall panels fit together.

STEP 2:

• Place 2 x 1.880 m wall sheets, 2 x 1.940 m wall sheets and 1 x

2.000m wall sheet on top of timber plates with bottom of sheets

flush with each other.

• Rivet sheets together on overlaps as shown

STEP 3:

• Nail wall sheets to the Top Plate at each end making

sure that the top corners of the sheets are flush with

the top of the Top Plate and that the sides of the wall

sheet overhang the Top Plate by approx 15mm as

shown.

• Check that the Top Plate is straight then nail the

Wall sheet to the Top Plate, 2 clouts per pan.

(see fig. 1).

Std Shed — Bottom Plate will protrude below

wall sheet by approximately 10mm.

Raised base plate shed — Wall sheet will protrude

below the Bottom Plate by 20mm

STEP 4:

• Nail the wall sheets to the Bottom Plate at each end ensuring each side

of wall sheets overhangs the end of Bottom Plate by 15mm. Check that

the distance between the Top and Bottom Plates is correct. (As per

diagram in step 1)

• Check that the Bottom Plate is straight then nail the wall sheets to the

Bottom Plate, two clouts per pan (see fig. 1).

REPEAT THESE STEPS TO MAKE SECOND SIDE WALL PANEL

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

Measurements between Top and

1810mm

15mm

CLOUT

RIB

PAN

TIMBER PLATE

fig.1

1810mm

15mm

TOP PLATE

BOTTOM PLATE

TOP PLATE

RIVET

BOTTOM PLATE

TOP PLATE

BOTTOM PLATE

1810mm

15mm

1810mm

15mm