DURAVAC CVWM510 Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DURAVAC CVWM510. DURAVAC CVWM510 14 pagina's. Wet/dry vacuums

Cleaning Foam Sleeve Filter

1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 4)

2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (ﬁg. 5)

3. Allow filter to air dry before installing and using again.

RESETTING THE REMOTE CONTROL

Resetting The Remote Control

1. Have the remote control accessible. Set the power switch on the vacuum to remote control

position "

". (fig. 1)

2. Press the RESET button on the side of the power head with a pointed object such as a paper clip or a

pen tip until the indicator lights up. (fig. 2)

3. Release the RESET button once the red indicator light lights up and immediately press and hold the "ON"

button on the remote control until the vacuum powers on. (fig. 3)

4. If the "ON" button is not pressed and held within a 15 second window, the reset will not be successful.

Repeat steps 2-3 to reset the remote control.

Changing The Battery – Replace Only With A 23AE 12V Alkaline Battery

1. Take a Phillips screwdriver and remove the screws on the remote control. (fig. 1)

2. Slide back the remote cover so that the white triangle on the remote cover points to the unlock symbol

" . (fig. 2 & 3)

3. Remove the remote cover from the handle. (fig. 4)

4. Lift the foam cover to expose the battery and remove the old battery. (fig. 5)

5. Insert the new battery with the terminals in the direction shown and make sure to replace the foam cover.

(fig. 6 & 7)

6. Replace the remote control by aligning the white triangle on the side cover to the unlock symbol "

on the handle. (fig. 8)

7. Slide the remote cover so that the white triangle is over the locked symbol "

8. Secure the cover with the screws. Do not over tighten. (fig. 11)

" . (fig. 9 & 10)