DuraVent DuraChimney II Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} DuraVent DuraChimney II. DuraVent DuraChimney II 16 pagina's. Air-cooled, all-fuel chimney for fireplaces

Pagina afdrukken
Frame Opening Dimension Chart
Diameter
10"
12"
14"
16"
ANCHOR PLATE
OR ANCHOR PLATE
WITH DAMPER
HI-TEMP
SEALANT
NOTE: DAMPER PLATE
IS CLOSED WHEN
CHAIN IS HOOKED
ON LINTEL HOOK
6
NorthlineExpress.com
Table 1
Framing Dimension
17" x 17"
19" x 19"
21" x 21"
23" x 23"
MASONRY
ANCHORS
Figure 2
ANCHOR PLATE
WITH DAMPER
Figure 3
http://www.northlineexpress.com
MASONRY FIREPLACE
INSTALLATION
1. Place Fireplace: Position the fireplace
according to the fireplace manufacturer's
installation instructions. The flue outlet should
be placed between the rafters or joists above,
if possible.
2. Determine Chimney Size: Follow the
fireplace manufacturer's instructions for
chimney size or use Table 2 (pg 11) to
determine the correct diameter chimney for
your fireplace.
3. Mount Anchor Plate: Chimneys for
masonry fireplaces begin with an Anchor
plate or Anchor plate with Damper. Warning:
Anchor plate with Damper is not allowed in
chimneys serving stoker-fired, liquid or gas-
burning appliances. Caution: Do not install
Anchor plate with Damper on Factory-built
fireplaces. Important: be sure the surface
of the masonry chimney has a level surface
on which to attach the Anchor Plate or
Anchor Plate. If the top of the masonry does
not have a level surface, then you will need to
modify the masonry accordingly. Center the
Anchor Plate over the masonry flue opening.
If a Damper is used, make sure nothing
interferes with the damper plate movement.
Seal the Anchor plate in place with a high-
temperature sealant. Secure Anchor plate
with (4) 2" x 1/4" masonry anchors (Fig. 2).
3a. Damper Plate: The Damper plate should
LINTEL
HOOK
swing freely once the Anchor plate is installed.
When the chain is pulled down, the damper
plate should close (horizontal position). When
the chain is released (no weight on the chain),
the damper should swing open (vertical
position).
3b. Lintel Hook: With the damper plate in
the closed (horizontal) position, determine
and mark the location for the Lintel hook. The
Toll-Free 1-866-667-8454