DARCHE ECLIPSE T050801794 Snelstarthandleiding - Pagina 5

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} DARCHE ECLIPSE T050801794. DARCHE ECLIPSE T050801794 8 pagina's. Pullout awning

Pagina afdrukken

Option 2 - Mounting directly to roof cross bars

2.1 Ensure the roof bars and brackets are

positioned so as not to exceed 600mm

from the ends of the awning.

2.2 Align the long side of the "L" shaped

brackets on to the roof bars as seen to

the right, with the brackets in suitable

position to allow easy access to the

awning, without it protruding to far from

the side of the vehicle.

2.3 Mark the holes and centre punch.

2.4 Drill the holes to clear the long bolts.

2.5 Bolt the "L" shaped brackets to the roof

bars.

2.6 Slide the head of the small bolts into

the mounting rail of the awning.

2.7 With help from another person, position

the awning onto the "L" shaped brackets

and install the nuts.

2.8 Align awning into desired position and

tighten all nuts and bolts from Steps

2.1-2.7.

2.9 Re-check all nuts and bolts periodically.

Option 3 - Mounting directly to a reinforced

steel /alloy canopy

3.1 If mounting directly to the roof of a canopy or trailer it is recommended that the "L"

shaped into the brackets are mounted cross braces built into the canopy and not directly

the sheet metal, as this will support the weight of the awning correctly.

3.2 Slide the smaller bolts into the mounting rail of the awning.

3.3 Loosely bolt the short side of the "L" shaped brackets to the canopy.

3.4 With help from another person, position the awning on the canopy. Ensure the brackets

are square, in line and ensure the awning will be able to function correctly. Ensure the

unsecured length at each end of the awning does not exceed 600mm.

3.5 Mark the mounting holes and remove th e awning.

3.6

Drill the holes in the canopy to clear the mounting bolts.

3.7

Refit the awning to the canopy with the bolts supplied.

3.8

Align awning into desired position and tighten all nuts and bolts from Steps 3.1-3.6.

3.9

Re-check all nuts and bolts periodically.