Addonics Technologies Z4RCS25HPM Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Addonics Technologies Z4RCS25HPM. Addonics Technologies Z4RCS25HPM 4 pagina's. Zebra disk array

How to mount SATA drive in the drive drawer
Screw Holes
1.
Remove the drive drawer from the disk array enclosure.
2.
Turn the drive drawer upside down and align the screw holes of the 2.5"
SATA drive.
3.
Using the screws provided, secure the SATA drive to the drive drawer.
Screw Holes
Model: Z4RCS25PM
Zebra Disk Array with integrated regular Port Multiplier -
Work with PM compatible controller only. The 4 drives in the Disk Array can be
set up as RAID 0, 1, 5, 10, JBOD when connected to a PM compatible RAID
controller or as individual drives via USB port.
Fan
Note:
No drivers are necessary for the Port Multiplier. You should have
configured the SATA host controller by installing its driver and utility
before connecting the port multiplier.
The Port Multiplier (PM) only works with SATA controller that supports PM or
FIS-based switching. Check with your system supplier to confirm the PM support
on your existing SATA port
In RAID BIOS of the SATA host controller, only one hard drive is detected on the
port multiplier even if all five hard drives are connected to the Port Multiplier. The
hard drive that is detected is the one connected to Port 1.
For SATA host controllers using SiI3124 or SiI3132 chip with RAID BIOS, it is in
the SATARAID5 Array Manager under Windows that all the connected drives will
show up.
For SATA host controllers using SiI3124 or SiI3132 chip with BASE BIOS, the
drives show up in Disk Management
Switch
eSATA Port
Power
Connector