4B ETH-SWITCH1V4C-5P Bedieningshandleiding - Pagina 8
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} 4B ETH-SWITCH1V4C-5P. 4B ETH-SWITCH1V4C-5P 16 pagina's. Industrial ethernet switch
Pagina afdrukken
The Control Unit is susceptible to static voltage, static handling precautions should be taken. Connection
of a clean ground to the Earth terminal is essential for optimum performance.
Static Hazard – Clean Only With A Damp Cloth
Remove Power Before Opening Cover – Do Not Apply Power When Cover Is Open.
All wiring must be in accordance with local and national electrical codes and should be undertaken by
an experienced and qualified electrician. All equipment should be properly grounded prior to operation.
Additional wire used during the installation must have a temperature rating of 158° F (70° C) or above,
and be at least 24 AWG. 4B recommends using shielded cable to reduce electromagnetic interference
(EMI) to maintain signal integrity. Never run low voltage cables in the same conduit as three phase
motor cables.
Use rigid metal conduit to protect the cables coming into the Ethernet Switch. Conduit systems can
channel water due to ingress and condensation which over time will adversely affect the performance of
the system. As such, the installation of low point conduit drains is recommended.
All electrical connections are shown in image 1.
FUSE RATINGS -
In order to maintain the product certification, all fuses MUST be replaced with equivalent fuses at the
same rating. Failure to do so will invalidate the certification and any warranties which may exist.
Model ETH-SWITCH1V4C-5P
• F5 200 mA.
WARNING
6. ELECTRICAL CONNECTION
PAGE 8