Apogee Apprentice 5039 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Apogee Apprentice 5039. Apogee Apprentice 5039 6 pagina's.

10. Apply wood glue to the back side of

the shock cord mount, and position it as deep

inside the front of the body tube as possible.

It needs to be at least 1-1/4" deep to allow the

nos cone to be put onto the tube. Allow the

glue time to fully dry.

11. Tie the loose end of the yellow shock

cord to the eyelet on the base of the nose

cone shoulder. Apply a drop of wood glue to

the knot to secure it in place.

12. Cut the parachute canopy from the

plastic sheet. Attach the six self-adhesive rings

to the corner points printed on the canopy.

Carefully poke a hole through the plastic in

the middle of each of the rings. Wind the

parachute lines as shown so you can cut the

shroud line string into three equal lengths.

Tie the three strings to the corners holes just

made. Tip: apply a drop of wood glue to each

knot to hold it permanently in place. Allow the

glue to dry before folding the parachute for

flight.

13. Holding the parachute at the center of

its top, pull the lines together to even up the

ends. Thread the three looped lines through

the loop at the base of the nose cone. Take

the top of the parachute and pull it through all

three string loops at the same time and then

pull to tighten the knot. This securely attaches

the parachute to the rocket.

Page

Position deeper than 1-

1/4" ( 3.2 cm)