Apogee Black Brant VC Handmatig - Pagina 2
Blader online of download pdf Handmatig voor {categorie_naam} Apogee Black Brant VC. Apogee Black Brant VC 16 pagina's.
Pagina afdrukken
Fuselage:
1. The three small green CR-18/24 centering rings
must be modified to make room for the engine
hook and shock cord. Using a sharp hobby knife,
cut a shallow notch 1/8" (3 mm) wide in two of the
rings. For the remaining ring, remove a full piece
1/8" (3 mm) wide to create a "c" ring.
2. With a pencil, mark the 2-3/4" (70mm) long
18mm tube at two points - 1/2" (13mm) and 1"
(25mm) from the one end of the tube - that is now
the forward end. Place a small cut 1/8" (3mm)
wide at the 1/2" (13mm) mark for the motor hook.
3. Insert the motor hook into the small slot cut in
the 18mm tube from the last step. The hook will
extend 1/2" (13mm) past the aft end of the motor
mount tube. With the motor hook thusly positioned,
apply wood glue to the line 1" (25mm) from the for-
ward end of the tube and slide one of the notched
centering rings into place behind the line (there
should be 1/2" or 13mm of the motor hook visible
on the forward side of the assembly).
4. Tie the kevlar shock cord around the forward
end of the 18mm tube, in front of the ring just
installed.
Inner Motor Band Strip
Outer Motor Band Strip
Sand Wedge to
Forward Edge
Page 2
THIS SECTION
NOT SHAPED
Sand Wedge
to Aft Edge
Step 1
Remove Small
Section
Cut two rings with a notch and one with a slot.
Step 2
Aft
Step 3
Step 4
Black Brant VC Marking Guide
1/8" (3mm)
1" (25mm)
1/2" (13mm)
Forward
1/2" (13mm)
1/2" (13mm)