APPA A10N Instructiekaart
Blader online of download pdf Instructiekaart voor {categorie_naam} APPA A10N. APPA A10N 4 pagina's. Clamp meter
Pagina afdrukkenA10N
Instruction
Clamp Meter
Card
Warning
Safety sheet
. . . . . . . . . .
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . .
Read First
Safety Information
To ensure safe operation and service
of the Meter, follow these instructions.
Failure to observe warnings can result
in severe injury or death.
- Avoid working alone so assistance can
be rendered.
- Do not use test leads or the Meter if
they look damaged.
- Do not use the Meter if the Meter is
not operating properly or if it is wet.
- Use the Meter only as specified in the
Instruction card or the protection by
the Meter might be impaired.
- Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could
result in electric shock.
- Use caution with voltages above 30 V
ac rms, or 60 V dc. These voltages
pose a shock hazard.
Symbols as marked on the Meter
and Instruction card
Risk of electric shock
See instruction card
DC measurement
Equipment protected by double or
reinforced insulation
Battery
Earth
AC measurement
Conforms to EU directives
Caution
If the meter is used in the vicinity of
equipment which generates electromag-
netic interference, the display may
become unstable or the measurements
show may be subject to large errors.
Off / On
Auto Power Off
10min
Auto Power Off disable :
Press backlight buttons than switch the
rotary knob to power on the Meter.
AC V / DC V
Resistance