AddSecure Iris Touch 220 Snelle installatie- en onderhoudshandleiding - Pagina 9
Blader online of download pdf Snelle installatie- en onderhoudshandleiding voor {categorie_naam} AddSecure Iris Touch 220. AddSecure Iris Touch 220 16 pagina's.
6.8.
Configuration
To configure your dialler, use one of the following methods:
Touch screen.
Alarm panel integration e.g. Honeywell Galaxy (RS485 connection).
Note: For connections to Honeywell Galaxy on the serial integration ensure you configure the
alarm panel first as this will transmit configuration to the IRIS Touch dialler.
For more details on the alarm panel integration download the full panel installation manual from
http://www.chironsc.com/downloads_security.html.
Connect the board's Micro USB connector to a laptop / PC running the IRIS Toolbox software.
Download the IRIS ToolBox user guide from http://www.chironsc.com/downloads_security.html.
Defaulting
If at any point you want to completely default the dialler you can use the following procedure:
1.
Enter the Installer menu on the dialler touch screen and enter the installer password.
2.
Go to the 'Settings' option and scroll down with the scroll bar on right till you see option for
'Default All'.
3.
Enter the 'Default All' and confirm the default, this will cause the dialler to reboot and will now
be defaulted.
Configuration via touch screen
IRIS Touch
can be configured directly using the on board touch screen using the supplied stylus.
IRIS Touch 200 or 240 with GPRS connection:
GPRS Network Scan
Select the 'Run Network Scan'.
The scan must be carried out without the SIM card fitted.
The dialler listens for every base station in range, requests operator name and records the signal strength.
This will take a few minutes to complete.
For a reliable GPRS connection it is recommended that for the chosen network (SIM card) used there
should be at least two base stations with signal strength (CSQ) of 10 or more.
If the signal strength is below or close to minimum then try to reposition the antenna or use an external
high gain antenna (if necessary), and rerun the network scan to gain best signal strength.
Enter the default installer code: 111111 and then click Logon.
You will be prompted to change the password, please record the new password.
Enter and confirm a new password and press 'Save'.
The Main Menu is displayed.
IRIS Touch
Quick Installation & Maintenance Guide Version 1.0
Page 9 of 16