Data Harvest EasySense Q 3 Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} Data Harvest EasySense Q 3. Data Harvest EasySense Q 3 20 pagina's.

Pagina afdrukken

1. What's in the Box

Technical Information for EasySense Q

System Menu

A system menu is accessed from the main menu. This will allow you to change the range

of a sensor, apply a factory reset and check the battery condition. To prevent accidental

change this menu can only be accessed if the user holds down both the red square and

yellow arrow buttons for 2 seconds.

Selecting the sensor range

The internal light sensor in EasySense Q and some plug-in Smart Q Sensors have more

than one range. The range can be altered either on EasySense Q (see below) or on the

computer by using the Sensor Configuration application in the Sensing Science program.

Once selected EasySense Q will use this range or units (until they are reselected).

Whilst in the main menu hold down the red square (stop) button and

then the yellow arrow (scroll) button and keep them both held down

for 2 seconds. The display will alter to show the System menu i.e.

Battery Level, Set Sensor Range and Factory reset.

Use the yellow arrow

Press the green triangle button

cursor until it is pointing to the relevant sensor i.e. the internal light sensor or the

Smart Q Sensor connected to external 1A or 2B. Press the green triangle (enter)

select. An asterisk (*) will indicate the currently selected range. Use the yellow arrow

to scroll the cursor down until it is pointing at the required range. Press the green triangle

(enter)

to select. The asterisk will move to indicate the selected range.

Press the red square (stop)

to the main menu.

Factory Reset

To reset EasySense Q back to its factory default condition i.e. clear all memory (all

stored data sets will be deleted) and set the built-in light level sensor range to the 0 –

1000 lux range.

Whilst in the main menu hold down the red square (stop) button and

then the yellow arrow (scroll) button and keep them both held down

for 2 seconds. The display will alter to show the System menu i.e.

Battery Level, Set Sensor Range and Factory reset.

Use the yellow arrow

reset'. Press the green triangle (enter)

A check message will warn that this reset will delete all data sets - press the green

triangle (enter)

to confirm your choice or press the red square (stop)

A message will confirm if the reset has been done, press the green triangle

to the main menu.

to scroll the cursor until it is pointing at 'Set Sensor Range'.

to select. Use the yellow arrow

to return to the system menu and then again

button to scroll the cursor down until it is pointing at 'Factory

to select.

button to scroll the

to return

to cancel.

to return