Data Signs RF REMOTE Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} Data Signs RF REMOTE. Data Signs RF REMOTE 6 pagina's.

Setting the RF Channel on the Remote

THE REMOTE MUST BE SET TO THE SAME CHANNEL AS

THE MASTER PTL CONTROLLERS

To set the RF Channel on the Remote Control, follow these

instructions.

1. Press the

screen to go to settings.

2. Press the RF Channel option.

3. Enter the new channel number.

4. Select the power level. 30% is good for

normal conditions. Increase this if you are

using the remote a long way from the Master,

however this will drain the battery quicker.

5. Press the OK button to save.

6. To re-start normal operation, press the BACK button.

POWER SAVING IN ADDITION TO PROPER USE WITH

LANYARD

To preserve power and battery life, set the time for the remote

to blank the screen and to power down. Setting these to a low

value will preserve battery and increase running time.

ADDITIONAL MONITORING

If operating more than two PTLs, slide the Slave AMBER button

to switch between the displays for each of the Slave units.

button on the bottom/left of the

R F R E M O T E M A N U A L