DURKOPP ADLER 867 Extra instructies - Pagina 9
Blader online of download pdf Extra instructies voor {categorie_naam} DURKOPP ADLER 867. DURKOPP ADLER 867 18 pagina's. Remaining thread monitor
Ook voor DURKOPP ADLER 867: Gebruiksaanwijzing (16 pagina's), Instructies (4 pagina's), Gebruiksaanwijzing (16 pagina's), Gebruiksaanwijzing (8 pagina's), Extra instructies (20 pagina's)
Pagina afdrukken
Settings
4
Fig. 4: Settingsn
(1) - Gauge A (Stitch length)
(2) - ESC key
(3) - F-key
4.1 Setting the feed distance
The feed distance can be set between a length of 1 – 15 mm per stitch in
increments of 1/10.
1. To change the feed distance of the top puller, press the Plus/Minus (D)
2. To change the feed distance of the bottom puller, press the Plus/
4.2 Setting the puller feed type
Two types of feed are available: Constant or intermittent feed. With inter-
mittent feed, the speed is restricted and depends on the feed distance set.
1. Open the parameter t 14 11.
2. Set the feed height:
Information
To change quickly between the feed types, the puller feed type can be pro-
grammed to the freely programmable F-key on the control panel (parame-
ter t 52 20 = 23).
See also DAC Control operating manual.
Additional Instructions 867 - 02.0 - 12/2016
Settings
①
②
③
buttons.
Minus (B) buttons.
• 0: constant
• 1: intermittent
A
B
C
D
+
+
+
+
ESC
–
–
–
–
P
④
(4) - Plus-/minus buttons forbottom
puller (B)
(5) - Plus-/minus buttons for top puller (D)
(6) - OK button
⑥
OK
RESET
⑤
7