Duro Dyne 27122 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Duro Dyne 27122. Duro Dyne 27122 17 pagina's. Pinspotter

SAF ETY PRE CAUT IO NS

Users Responsibility

This equipment will perform in conformity with the description and all the instructions contained in this manual

provided. The equipment must be checked periodically. Defective equipment should NEVER be used with parts

that are broken, missing, worn, distorted or contaminated and should be replaced immediately.

Should such repair or replacement become necessary, the manufacturer recommends that a telephone or

written request for service advice be made to the Authorized Distributor from whom purchased.

THIS EQUIPMENT OR ANY OF ITS PARTS SHOULD NEVER BE ALTERED WITHOUT THE PRIOR WRITTEN

APPROVAL OF THE MANUFACTURER. THE USER OF THIS EQUIPMENT SHALL HAVE THE SOLE RESPON-

SIBILITY FOR ANY MALFUNCTION WHICH RESULTS FROM IMPROPER USE, FAULTY MAINTENANCE,

DAMAGE, IMPROPER REPAIR OR ALTERATIONS BY ANYONE OTHER THEN THE MANUFACTURER OR A

SERVICE FACILITY DESIGNATED BY THE MANUFACTURER.

**WARNING**

These safety precautions are for your protection. They summarize precautionary information

listed above. Before performing any installation or operating procedures, be sure to read

and follow the safety precautions as well as all other operation instructions in this manual.

FAILURE TO OBSERVE SAFETY PRECAUTIONS AND OPERATING

PROCEDURES CAN RESULT IN INJURY OR DEATH.

**COMPLY WITH ALL ELECTRICAL, FIRE AND OTHER APPLICABLE CODES OR ORDINANCES IN THE

INSTALLATION AND USE OF STUD WELDING SYSTEMS.

**REMOVE ALL COMBUSTIBLE OR VOLATILE MATERIALS FROM WELD AREA. Although weld splatter re-

sulting from stud welding is normally minimal, proper precautions should be taken when welding near or through

combustible materials to insure that sparks or weld material does not come in contact with combustible material.

**RECOMMENDED USE OF PROPER EAR PROTECTION WITH ALL CAPACITOR DISCHARGE STUD WELDING

SYSTEMS. The stud welding operator and anyone working within five feet (5') of the stud welding operation

should use ear protection devices.

**RECOMMENDED USE OF PROPER EYE PROTECTION AT ALL TIMES WHEN WELDING. Spectacle type

frames with Shade No. 3 absorptive and filter lens with side shields are suggested. Never look directly at the

weld arc without wearing eye shields.

OVERUSE CAN CAUSE OVERHEATING

**Allow cooling period; follow rated duty cycle. Reduce current or reduce duty cycle before starting to weld again.

**Do not block or filter airflow to unit.

WELD TIP CAN CAUSE INJURY

**Do not press weld gun trigger with hands or tools near weld tip or chuck.

PROTECT YOUR EYES

**Always wear safety glasses with side shields in any work area.

PROTECT YOUR EARS

**Always use ear protection devices.

-3-