Duro Dyne PLSU3 Werkingstheorie - Pagina 5

Blader online of download pdf Werkingstheorie voor {categorie_naam} Duro Dyne PLSU3. Duro Dyne PLSU3 8 pagina's.

Pagina afdrukken

1) Power up your PLSU3 machine by plugging the 110VAC line cord into a 110VAC power source.

2) To turn the machine on, ensure that BOTH

the machine. The machine will not turn on unless

3) Locate the air regulator assembly that is located underneath the table of the PLSU3. Connect the

air supply and turn on the air supply. Adjust the air regulator to 80 PSI by turning the regulator

knob clockwise to increase air pressure and counterclockwise to decrease the air pressure.

4) Load your insulation into the PLSU3 liner dispenser and begin feeding it through the machine, by

following these steps:

a. Press down one of the

ensure air pressure has been dumped from the system to allow a safe material loading

process.

b. Secure the material guide using the hardware already in place on the inner (least

accessible) side of your machine.

c. Pull down the upper roller lifter handle to un-pinch the rollers and begin feeding your

insulation through the machine. Make sure to feed the insulation

table-mounted reflector, as pictured below:

Pic 5.1.

d. Release the upper roller lifter handle to secure and pinch your insulation in the machine.

e. Twist the

red

pressure back to the machine.

5) You can now perform a crop cut to zero the machine's encoder. This manual cut is vital to ensure

accurate cut lengths during your cutting program. Be sure to perform this cut

material into the machine. Ensure the material/insulation is past the eye sensor (see step 5), then

press "Manual Screen" (lower right corner). On the Manual Screen, use the "Cross Cut" button to

make one manual cut and remove the cut material from the machine.

6) Switch back to the main screen and enter your cutting program by setting the "cut length" to the

desired length of insulation and by setting the "cut count" to the desired number of pieces

needed to be cut. Press the parameter's value to edit the value, enter the value, and press ENTER.

7) Press the green

start

remove the cut-to-length material from the machine to allow the cutting program to keep running.

8) Once the machine reaches the set number of cuts entered by the operator, the motor will stop

running and no more pieces will be cut. The "cut count" value will match the "current count" value

on the screen. Press "reset" before running a new cutting program to reset the count to zero.

PLSU3: Getting Started

red

emergency stop buttons on either side of the machine to

Correct

emergency stop button clockwise and pull up to release it and bring air

button to begin cutting your material. After each cut is made, be sure to

green

power buttons are depressed on either side of

BOTH BUTTONS

Pic 5.2

are pushed down.

past

the eye sensor and

Incorrect

every time

you load