DataComm 45-0051-WH Instructie-/installatieblad - Pagina 2

Blader online of download pdf Instructie-/installatieblad voor {categorie_naam} DataComm 45-0051-WH. DataComm 45-0051-WH 2 pagina's. Expandable media box with duplex receptacle

Pagina afdrukken

Instruction / Installation Sheet

Expandable Media Box

with Duplex Receptacle

Part # 45-0051-WH CONTINUED

Installation Instructions:

Fig. 1

Figure 2:

Fig. 2

Refer to the included template to make your cutout. Once you have made the

cutout, return to Figure 3 of this instruction sheet and complete installation.

Fig. 3

Figure 3:

Run the source of power to the included Old Work Electrical Box. Be sure to follow all

local electrical codes.

Figure 4:

Fig. 4

Connect the supplied Duplex Receptacle to a piece of 14/2 with ground UL approved

electrical building wire that you have pulled from a power source. Strip off approximately 3

inches of the outer jacket of the wire. Be careful not to cut the jacket of the inner wires.

Connect the hot line (black) wire to the brass colored terminal screw and neutral (white)

wire to the silver colored terminal screw. Be sure to connect the grounding (green) or bare

grounding wire to the green colored terminal screw. Once you have wired the Duplex

Receptacle, screw it into the Old Work Electrical Box until the receptacle is firmly secured.

Fig. 5

Figure 5:

Use the four provided screws to secure the Old Work Electrical Box and Receptacle

to the mounting studs on the back side of the Expandable Media Box.

Figure 6:

Fig. 6

Important: Before installing the Expandable Media Plate into the template opening, make

sure to pull your low voltage cables through the low voltage cable opening.

After pulling low voltage cables through: Insert the receptacle side of the

Expandable Media Box first, slowly sliding it into the opening. Be sure the four (4) metal

wings are folded in and swing the right side of the Media Box into position until the entire

Media Box is flush with the wall. Now screw down the screws with wings; these wings

fasten tightly against the back of the drywall. Push Expandable Cavity into place.

Fig. 7

Figure 7:

Your new Expandable Media Box with Duplex Receptacle is now installed and ready for

the TV mount to be installed. Install your TV mount bracket per the TV bracket

manufacturer's instructions.

Figure 1:

Top view - shows needed space between the

drywall and the studs.

Page 2 of 2

888.223.7977

770.662.8205

www.DataCommElectronics.com

05/01/2014