4IPNET HSG1250 Snelle installatiehandleiding - Pagina 4

Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} 4IPNET HSG1250. 4IPNET HSG1250 13 pagina's. Wireless hotspot gateway

Pagina afdrukken

System Overview

Front Panel

LCD Display: Allows network administrator to check important system settings such as network interface,

SZ configurations, etc. The navigations buttons from left to right respectively are "Sleep", "Esc", "Up",

"Down", and "Enter".

Function Buttons: There are four function buttons.

Reset: Press and hold the Reset button for over 3 seconds and status of LED on front panel will

start to blink, release button at this stage to restarting the system. Press and hold the Reset button

for more than 10 seconds and status of LED on the front panel will turn from blinking to off, release

at this stage to reset the system to default configuration.

Quick-Restore: This button is the firmware switch button. Press this button while system is

powering up and release when the "Quick-Restore" LED lights up, the system will switch to the other

firmware image and boot up with that firmware.

Quick-VPN: This button is for establishing a site to site VPN tunnel with minimal pre-configurations

at a push of a button. Please refer to user's manual for detailed operation instructions.

Quick-Maintenance: This button allows admin to copy an exact FW & Configurations from

controller A to controller B except for MAC address. Please refer to user's manual for detailed

operation instructions.

LED Displays: There are five LED light displays.

Power: Power LED lights up as constant yellow green when power supply is on.

Status: Status LED is Blue. Blinking indicates that system OS is booting up, when lit up constantly

indicates that the system is ready for operation.

Quick-Restore: This is used to indicate that the system will now switch to the other F/W partition for

operation.

Quick-VPN: This LED is used for indicating the status of establishing site to site VPN tunnel with

minimal pre-configurations at a push of a button. Please refer to user's manual for detailed status

description.

Quick-Maintenance: This LED is for indicating the status of copying FW & Configurations from

controller A to controller B except for MAC address. Please refer to user's manual for detailed status

HSG1250

Wireless Hotspot Gateway

HSG1250

②

Quick Installation Guide

ENGLISH