Datalogic Gryphon GD4130 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Datalogic Gryphon GD4130. Datalogic Gryphon GD4130 4 pagina's. General purpose usb corded handheld - linear imager 1d barcode reader

Pagina afdrukken

This section provides programming barcodes to configure your Reader for use with the USW program. Scan the barcodes on the

following pages in order of appearance. You will begin and end with the Enter/Exit Programming Mode barcode. When the Reader

is in Programming Mode its top LED blinks continuously and after you scan each barcode the Reader will emit a specific (tone

pattern). It is advisable not to rush through the programming sequence. Allow the Reader time to accept the encoding – listen for

the tones.

Enter Programming Mode

Scan the Enter/Exit Programming Mode barcode to begin Reader setup for the USW program.

Enable Interleaved 2 of 5 Standard

This setting will enable your Scanner to read the Interleaved 2 of 5 Symbology printed by the USW program.

I 2 of 5 Minimum Reads

The following specifies the minimum number of consecutive times an Interleaved 2 of 5 Label must be decoded before it is

accepted as a good read.

~ (tone pattern) # > # # # # ~

~ (tone pattern) # # ~

Page 2 of 4