4IPNET WHG505 Snelle installatiehandleiding - Pagina 5

Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} 4IPNET WHG505. 4IPNET WHG505 10 pagina's.

H a rd wa re I n sta l l a tio n

Please follow the following steps to install WHG505:

1. Connect the power cord to the power socket on the rear panel.

2. Turn on the power switch on the rear panel. The Power LED should be on to indicate a proper connection.

3. Connect an Ethernet cable to the WAN1 Port on the front panel. Connect the other end of the Ethernet

cable to an xDSL/cable modem, or a switch/hub of an internal network. The LED of this port should be on

to indicate a proper connection.

4. Connect a crossover Ethernet cable to the Mgmt Port on the front panel. Connect the other end of the

Ethernet cable to an administrator PC for configuring the WHG505 system, an AP for extending wireless

coverage, a switch for connecting more wired clients, or a client PC. The LED of Mgmt port should be on to

indicate a proper connection.

Usually a straight RJ-45 could be applied if WHG505 is connected to a hub/computer which supports

automatic crossover. However, after the Access Point hardware is reset, WHG505 would not be able

to connect to the Access Point while connecting with a straight cable unless the cable was pulled out

and plugged in again. This scenario does NOT occur while using a crossover cable.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

Quick Installation Guide

W H G5 0 5

Secur e W L A N C o n t r o l l er

E N G L I SH