Dust Free BIO-FIGHTER Ultra-Flex 1S Installatie- en bedieningshandleiding - Pagina 6

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Dust Free BIO-FIGHTER Ultra-Flex 1S. Dust Free BIO-FIGHTER Ultra-Flex 1S 7 pagina's. Ultraviolet light systems

Pagina afdrukken

BIO-FIGHTER® ULTRA-FLEX INSTALLATION & OPERATION MANUAL

LAMP REPLACEMENT(Annually)

The lamp should be replaced annually even if

it appears to be operating normally. UV-C

energy production diminishes over time.

1. Obtain the correct replacement lamp for

your model.

2. Disconnect power to the equipment. Allow

lamp to cool 10 minutes before touching.

4. Disconnect the lamp harness.

5. Remove the remote lamp housing. (Not

required for internal lamp mount option.)

6. Unscrew the two knurled nuts of the lamp

retaining bracket and slide the bracket

away from the lamp retaining lip. For inter-

nal lamp mount option, remove the two

knurled nuts and lamp retaining washer.

7. Carefully remove the UV-C lamp and

replace it with the new lamp. Be sure to

clean the lamp of dust and fingerprints

prior to installation.

8. Slide the retaining bracket back in place

and tighten knurled nuts. For internal lamp

mount option, secure the lamp with the

lamp retaining washer and fasten with

knurled nuts.

9. Reattach the remote lamp housing. The

remote lamp housing must be in place

prior to attaching the lamp harness. (Not

required for internal lamp mount option.)

10. Reconnect lamp harness.

11. Reconnect power.

12. Verify operation using viewport.

WARNING

Burn Hazard.

During replacement, allow lamps to cool 10 minutes

before removing them. Personal injury may result.

WARNING

Mercury Hazard. Do Not Break.

Each UV-C lamp contains a small amount of Mercury.

May cause redness or irritation. Use proper disposal

techniques in case of breakage.

PROPER CLEAN-UP TECHNIQUE IN CASE OF

LAMP BREAKAGE

Wear protective gloves, eyewear and mask.

Sweep the broken glass and debris into a plastic

bag, seal the bag, and dispose of properly.

Contact your local waste management office for

proper disposal.

Do not use a vacuum cleaner. Do not

incinerate.

LAMP DISPOSAL

Dispose of your spent UV-C lamps at your

local recycling center. You may also send your

spent lamps in the same container you

received your replacement lamps to:

Dust Free® Lamp Reclamation

1112 Industrial Drive

Royse City, TX 75189

Replacement Parts

UVC Lamp - 14"

UVC Lamp - 16"

UVC Lamp - 20"

UVC-O3 Lamp - 14"

UVC-03 Lamp - 16"

UVC-O3 Lamp - 20"

Ballast - Multi-Voltage

Power Cord - Whip-Type

On/Off Switch

Slide Bracket Springs (2)

Slide Bracket

Knurled Nuts (2)

Fuseholder

Fuse

For information on the dealer in your area call: 1-972-635-9564.

Visit us at http://www.dustfree.com

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent loss of

vision, and sunburn. Take precautions to protect eyes

and skin from direct exposure.

Part No.

06413

06417

06421

06415

06419

06423

06426

06303

06617

210-0005-001

210929-00

210226-00

212225-00

750-0108-001