elsner elektronik 70711 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} elsner elektronik 70711. elsner elektronik 70711 2 pagina's. Radio actuator
Ook voor elsner elektronik 70711: Technische specificaties en installatie-instructies (2 pagina's)

Pagina afdrukken

2.3.1. Device Design

Inout mains voltage

STAS3 slot for STAK3 coupling

PRG

LED

PRG

magnet

1 Neutral conductor

2 L

3 nc (not connected)

2.4. Establish radio connection

The device is integrated into the KNX system with a media coupler or a KNX RF USB

stick. (For further information see the corresponding manual/data sheet.)

1. Start the programming mode of the KNX RF-MSG with the enclosed magnet (te-

lescopic rod). The programming LED lights up.

2.5. Activate retransmitter function

If the device is set up as a retransmitter, it

transmits all received KNX RF telegrams.

These can be received by KNX RF partici-

pants with the same domain address. As a

result, the radio range of a KNX RF system

can be increased.

The function must be activated in the ETS in

the property window of the device by tic-

king the box "Retransmitter".

2.6. Notes on mounting and commissioning

Device must not be exposed to water (rain). This could result in the electronic being

damaged. A relative air humidity of 95% must not be exceeded. Avoid bedewing.

Address the device on the bus

The equipment is delivered with the bus address 15.15.255. A different address can

be programmed in the ETS by overwriting the address 15.15.255 or by holding a ma-

gnet on the PRG magnet.

Disposal

After use, the device must be disposed of or recycled in accordance with the legal

regulations. Do not dispose of it with the household waste!

Radio actuator KNX RF-MSG-ST as of version 1.1 • Version: 09.06.2020 • Technical changes and errors excepted. • Elsner Elektronik GmbH • Sohlengrund 16 • 75395 Ostelsheim • Germany • www.elsner-elektronik.de • Technical Service: +49 (0) 7033 / 30945-250

Radio actuator KNX RF-MSG-ST

Motor output

STAK3 coupling

for STAS3 plug

1 Neutral conductor

2 Up

3 Down