Dust Networks D2120 Snelstarthandleiding - Pagina 17

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dust Networks D2120. Dust Networks D2120 18 pagina's. Evaluation kit

Setting Up a Network

This chapter describes how to set up a D2120 Evaluation Kit in a simple sensor

network. For a more detailed explanation, see the Getting Started Guide that came with

your Evaluation Kit.

A Install the SmartMesh Console software.

B Connect Manager to the PC using the cross-over cable.

C Connect power to the Manager.

D If necessary, adjust the IP address of the PC to allow connection with the manager.

E Start Console.

F Connect to Manager.

G Go on to set up the network.

A Power up one evaluation module by resetting it.

B Press the Test button on the module.

The green Power LED should turn on. If it does not, make sure that the batteries are

C Form the network by powering up additional modules (repeat steps 1 and 2).

D Use the Console to verify network connectivity. For more information about

D2120 E

VALUATION

UICK

TART

properly seated. The Link LED starts blinking when the module has found the

network. When the module joins the network, the Link LED remains on.

configuring and managing the network, refer to the SmartMesh Network

Administration Guide.

UIDE