Dust Right 42401 Instructies - Pagina 4

Blader online of download pdf Instructies voor {categorie_naam} Dust Right 42401. Dust Right 42401 4 pagina's. 4" through-the-wall port kit

Pagina afdrukken

Installation

1. Decide on a location for the Dust

Right

Through-The-Wall Port Kit.

Make sure that the mounting

location will not intersect any

wall studs, plumbing, electrical

wiring or ductwork. Also make

sure it will be possible to create

aligned openings on both sides of

the wall; if the holes are misaligned,

the wall-mount combo ports will not

mount flush against the wall.

2. Mark and carefully cut a 4" diameter

hole in one wall. Options for making

this cut include a hole saw, a jigsaw,

a rotary tool or a jab saw.

3. Mark a corresponding hole on the

opposite wall. Make sure that the

hole will align with the hole you cut

in the first wall.

4. Carefully cut a 4" diameter hole

in the second wall and spread or

cut through any insulation in the

installation area.

5. Drill a hole in all four corners of

each wall-mount combo port for a

mounting screw (not included).

6. Attach the 4" diameter tube to one

of the wall-mount combo ports with

silicone adhesive or ABS pipe

cement. Allow the adhesive to

cure as specified in the

product instructions.

7. Fit the 4" diameter tube into the hole

in the first wall and out the hole in

the second wall. Advance the tube

until the combo port is flush against

the wall.

8. Square up the wall-mount combo

port and use the holes you drilled

in the flange to mark drilling

locations on the wall. Drill the holes.

Depending on your application, you

might need small pilot holes for

42401

Rev 07/22

9. At the second wall, make sure the

10. Reinsert the tube in the hole and

11. At the second wall, fit the remaining

12. Remove the combo port; apply

13. Drive screws to attach the combo

Check Rockler.com for updates to these

instructions. If you have further questions, please

contact our Technical Support Department at

1-800-260-9663 or [email protected]

Distributed by Rockler Companies, Inc.

4365 Willow Dr. Medina, MN 55340

screws or larger holes for wall

anchors. (Screws and wall anchors

not included.)

tube is extending as far as it will go.

Then make a mark on the tube

⁄

" out from the wall. Remove the

4" diameter tube from the wall and

carefully cut it to the length you

just marked.

advance it until the combo port is

flush against the wall. Attach the

combo port to the first wall

with screws.

combo port onto the 4" diameter

tube and position it square. Then

use the holes you drilled earlier in

the combo port flange to mark

drilling locations in the wall for

screws or wall anchors (not

included). Drill the pilot holes.

silicone adhesive or ABS pipe

cement and fit the combo port back

onto the 4" diameter tube, squaring

it so the holes in the flange line up

with the holes or anchors in the wall.

Press the combo port flush against

the wall.

port to the wall. Allow the adhesive

to cure as specified in the

product instructions.

1-800-279-4441