Dustbane Integra DS Bedieningshandleiding - Pagina 4

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Dustbane Integra DS. Dustbane Integra DS 6 pagina's. Polisher floor

4. Getting Started

Your polisher has been assembled to allow

you to operate the machine within a few

minutes after removal from the shipping

carton. There are several procedures to

follow that will ensure a safe and proper

start-up.

1. Check the machine over completely

after removal from the carton. Any

damage or missing pieces must be

reported to your sales representative

immediately.

2. Dual/Single speed models: Each unit

requires a drive pad and floor pad.

Before plugging the unit into an AC

outlet, lay the machine back down on

its wheels and handle and install the

drive pad onto the motor gearbox by

engaging it into the hub and turning it

counter-clockwise (as viewed from the

bottom). The drive pad must seat fully. Center the floor pad and press lightly to allow the drive pad to grip it.

Uhs models: Drive pad and floor pads are already installed before shipping. The floor pad may be replaced by

turning the "Center-Lok" counter clockwise to remove. Replace pad by centering it on drive pad and re-install

"Center-Lok".

3. Return the unit to the upright position and plug protected with a rating no higher than 15 amps. it into a

grounded 115v AC wall outlet. The outlet should be breaker

1. Loosen the handle adjustment lever by pulling it to the upright position. Pull the handle back to a comfortable

operating position and lock the lever by pushing it forward. Do not start the machine with the handle in the

upright position.

2. Start the machine by putting both hands on the handle, push either safety lever down with one finger then

pull up on the trigger. The motor will start and will pull to one side or the other. Adjust the speed selector

switch for low or high speed operation.

3. Dual/Single Speed Models - Lift on the handle to put weight on the front and the polisher will pull to the right.

Push down and the polisher will pull to the left. When balanced, the polisher will remain stationary. Be sure to use

both hands for proper control of the machine. Maintain a hold on the machine until it comes to a complete stop.

UHS models — The unit is supported by two rear wheels and a third adjustable front wheel. The machine is

preset at the factory but may be easily changed. With the machine off, apply more pressure by turning the

adjustment knob counter clockwise. Turn it only 1% to ½ turn and check each time by restarting as in (2) above.

Turn the adjustment knob clockwise to lessen the pressure on the pad. There will be a change in both speed

and sound of the machine as the pressure is changed. Too much pressure may cause serious problems by over-

loading the motor and tripping a circuit breaker. Too little pressure will not produce the desired results.

4. Dual/Single Speed Models - To apply extra pressure on tough to clean areas or to seat the drive pad 'heel' the

polisher by lifting the left edge of the chassis to force the right edge of the drive pad down on the floor. Use

caution when doing this.