Datalogic DS4800 Snelle referentiehandleiding - Pagina 3
Blader online of download pdf Snelle referentiehandleiding voor {categorie_naam} Datalogic DS4800. Datalogic DS4800 16 pagina's.
Ook voor Datalogic DS4800: Snelle referentiehandleiding (13 pagina's), Snelle referentiehandleiding (13 pagina's)
Pagina afdrukken
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAXIMUM OUTPUT RADIATION 1 mW
EMITTED WAVELENGTH 630~680 nm
TO EN 60825-1:2001
AVOID EXPOSURE TO BEAM
CAUTION-CLASS 3B LASER LIGHT WHEN OPEN
LASER LIGHT EMITTED FROM THIS APERTURE
Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to
hazardous laser light.
The laser diodes used in this device are classified as Class 3B laser products according to EN 60825-1 regulations
and as Class IIIb laser products according to CDRH regulations. As it is not possible to apply a classification label
on the laser diodes used in this device, the following label is reproduced here:
Any violation of the optic parts in particular can cause radiation up to the maximum level of the laser diode (35
mW at 630~680 nm).
Power Supply
The supply voltage for correct operation of the scanner depends on the models:
-
between 20 and 30 VDC, supplied to the Lonworks Network connector, for DX8200 Controller-
X0X0 models
between 85 and 264 VAC, supplied through the VAC power cable, for DX8200 Controller-X0X1
-
models.
A security system allows the laser to activate only once the motor has reached the correct rotational speed;
consequently, the laser beam is generated after a slight delay from the power on of the scanner.
During power up of the scanner there is a current peak of about 3A caused by the motor startup.
LASER LIGHT
Warning and device class labels
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAXIMUM OUTPUT RADIATION 35 mW
EMITTED WAVELENGTH 630~680 nm
Laser diode class label
DATALOGIC S.P.A. Via Candini, 2
40012 Calderara di Reno - Bologna - Italy
Manufactured
Model No.
Serial No.
This product conforms to the applicable requirements
of 21CFR1040 at the date of manufacture.
LASER LIGHT
TO EN 60825-1 (2001)
DX8200 CONTROLLER
QUICK GUIDE
Volt
Amp.
3