Datalogic MAGELLAN 3410VSi Integratiehandboek - Pagina 9
Blader online of download pdf Integratiehandboek voor {categorie_naam} Datalogic MAGELLAN 3410VSi. Datalogic MAGELLAN 3410VSi 20 pagina's. Omni-directional imaging scanner
Pagina afdrukken
HOUSING DESIGN
The enclosure must be designed to prevent internal reflections from illumination and
aiming systems into the receiving optics. It is not recommended to place any type of
additional window between the scanner and the bar code to be read.
The housing design must provide adequate ESD protection for the scanner. Ideally, static
discharge should not be allowed to discharge to the scanner. The preferred method to
prevent static discharge is to provide a long discharge path to all circuits. Only the front
surface should be exposed in order to read bar codes. This is to protect the rear inter-
face connector area which can be susceptible to static discharge. Interface cables
should also not be powered up when inserted into the scanner. It is also recommended
that any metal mounting surfaces for the scanner be electrically grounded.
Static discharge (ESD) testing is recommended for the entire system integration to
ensure proper ESD protection. Proper ESD protection should be used at the time of
installation and servicing of the scanner or the host equipment.
MOUNTING HOLES
There are four mounting holes located on the 4 corners of the window. The recom-
mended size for the screws is 3mm. See "
plate drawing of the mounting holes.
INTEGRATING THE SCANNER BEHIND A WINDOW
It is not recommended to place any type of additional window between the scanner and
the bar code to be read. The addition of a host enclosure window will significantly
degrade scanner performance. This is due to the additional reflective surfaces that will
cause optical interference with the imaging.
SCANNER CLEARANCE FOR INTEGRATION
To avoid damaging the 3410VSi OEM scanner by accidental impact or Electro Static Dis-
charge, maintain 0.38 in clearance between the scanner and any other items in the cus-
tomer enclosure (except front mounting surface).
Mounting Template" on page 14
HOUSING DESIGN
for a 1:1 tem-
6
INTEGRATION GUIDE