Dataman ROV MS2200 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dataman ROV MS2200. Dataman ROV MS2200 7 pagina's. Laser barcode scanner

How to scan with the ROV Scanner:

•

Hold ROV Scanner at an angle to the bar code approx 10 – 15 degrees

•

Position ROV Scanner between 12 – 18 cm from the bar code

•

Gently (but firmly) press the front of the scan button until it bottoms out

•

Move scan beam through the bar code, while slowly bringing the ROV closer to the bar code

•

Scan beam must extend at least 1 cm beyond edges of bar code

Second, let's review how to deal with worn, damaged or covered bar codes:

Many times, the bar code may be ripped, faded of poor quality or has been covered with a clear

protective overlay. If a bar code does not immediately scan then slowly move the scan beam from the

top of the bar code to the bottom. This gives the scanner a better chance to find "good spots" within

the bar code, if the protective overlay is not completely flat or clear and gives off false reflections then

permanent errors and the total inability to read the bar code underneath can result. In cases like this

the solution lies with replacing the covered bar code and not with the bar code reader.

What if there's no scan at all?

•

If no scan: check battery orientation & replace batteries, if needed

•

Scanning distance may vary depending on bar code size and density. Scanning distances

range from: 2.5 – 20 cm

•

Protective overlay may be causing excessive bad reflections.

•

Good Scan: LED blinks, beeps, and scan beam turns off

•

Memory Full: LED blinks 3 times & scanner beeps 3 times

Dataman Barcode Systems

P.O. Box 855

Happy Valley, S.A. 5159

Australia

Tel:-

088 322 7675

Fax:-

088 322 7288

E-mail:-

Web:-

www.datamanbarcode.com.au

Int Tel:- +(618) 8322 7675

Int Fax:- +(618) 8322 7288