4M Water Pump Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} 4M Water Pump. 4M Water Pump 2 pagina's. Hybrid solar-powered water pump

Pagina afdrukken

3. Insert the joint into the socket as shown.

4. Clip the solar panel into the battery case's joint.

Remark: The oil drop symbol indicates the areas which may require lubrication. It is recommended that you apply some cooking oil or

lotion to the joints or moving parts when assembling the product. This helps to reduce friction and enhance mechanical performance.

5. Lubricate the motor head and shaft with cooking oil or lotion before inserting it into the gearbox with the wires facing you. Place the

motor cover over top allowing for the wires to come out of the cover's slot. Secure with two small screws.

6. Slide the gearbox and battery module into position.

7. Secure two black wires in the left terminal, two blue wires in the middle terminal and three red wires in the right terminal with a

terminal cap.

8. Check this diagram to ensure you have connected the wires correctly.

QUESTIONS AND COMMENTS

We value you as a customer and your satisfaction with this product is important to us. If you have any comments or questions, or you find any parts of

this kit missing or defective, please contact our distributor in your country, whose address is printed on the packaging. You are also welcome to contact

our marketing support team via email: [email protected], fax (852) 25911566, telephone (852) 28936241, or our website: WWW.4M-IND.COM.

RED

BLUE

BLACK

RED

BLUE

9. Align each notch with the small cutout on parts (C, I, J1, and J2) as shown in the small diagram. Insert (J2)'s 3 joints into the holes on

the pump base to secure the completed cylinder in place. Water will flow smoothly through the system only if the pieces are connected

correctly. Finally, connect the main frame to the pump base as shown.

10. Use pegs to connect the piston and small motor joint to the piston connector. The small motor joint should be inserted from the flat

side of the piston connector. Remember to lubricate the areas identified by the oil symbol.

11. Connect the small motor joint to the gearbox and then slide the piston into the cylinder.

12. Create a secure connection between the piston and cylinder connector by inserting a peg as shown. Remember to lubricate the

areas identified by the oil symbol.

13. Connect the arms, figure body and large gear joint together with a peg. Clip the legs to the figure body. Punch out two faces from

the product's packaging and push them into the head.

14. Insert the figurine connector into the bottom of the battery case. Slide the large gear joint onto the gearbox and figure onto the joint

connected to the battery case.