4M TABLE TOP ROBOT FL2 Instructies - Pagina 2

Blader online of download pdf Instructies voor {categorie_naam} 4M TABLE TOP ROBOT FL2. 4M TABLE TOP ROBOT FL2 2 pagina's.

D. ASSEMBLY

1. Put the chassis with motor installed on your work surface, the same way round as in the diagram. Push

one of the axles (Part J) into the hole next to the large gear wheel in the chassis, and slide one of the gears

(Part K) onto it, so that the gear interlocks with the large gear wheel.

2. Push the other axle into the hole in the motor recess, next to the first gear. Slide another gear onto it, so

that this gear interlocks with the first gear, and the worm gear of the motor.

3. Slot the battery case into place on top of the chassis, making sure that the axles slot into the two holes

on the underside of the case. Secure it with two screws (Part G).

4. Put the red wire from the battery case and the red wire from the motor into one of the terminals, and

push in a terminal cap (Part I) to trap and connect the wires. Put the black wire from the battery case and

the black wire from the switch into the other terminal, and push in a terminal cap to trap and connect the

wires.

5. Make sure the switch is off. Slot a 1.5-volt, AA battery into the battery case, with the negative terminal

of the battery (the flat end) touching the spring in the battery case.

6. Put the transparent cover over the battery case. Fit the cover into the two slots at the rear of the chassis.

7. Hold the metal wire antenna (Part H) in place and attach it and the

transparent cover to the battery case with a washer screw (Part F). You

can gently bend the wire to adjust the angle of the antenna.

8. Clip four legs into one end of the chassis.

9. Clip four legs into the other end of the chassis.

10. Clip the two claws onto the chassis.

Congratulations! Your Table Top Robot is ready to go!

TOP VIEW

BLACK

Questions & Comments

We value you as a customer and your satisfaction with this product is important to us. If you have comments or questions, or you

find any part of this kit missing or defective, please do not hesitate to contact our distributor in your country. You will find the

address printed on the package. You are also welcome to contact our Marketing Support Team: Email: [email protected],

Fax (852) 25911566, Tel: (852) 28936241, Web site: WWW.4M-IND.COM

RED

BLACK