Dataprobe IP-2815 Handmatig - Pagina 3
Blader online of download pdf Handmatig voor {categorie_naam} Dataprobe IP-2815. Dataprobe IP-2815 13 pagina's. Dual input web controlled power switches
Pagina afdrukkeniP-28xx
Hardware Installation
Important Note: Make all communications connection prior to applying power. To change communications cables, remove
power or power cycle the unit after connections.
J2 - 10baseT Connector
The 10baseT connector is located on the rear panel of the switch. It provides connection to the Ethernet.
Note: Connection to an Ethernet hub is made using the cable provided. To directly connect to a PC, a crossover
cable is required. This cable is available at any computer store.
An LED on the jack indicates when the connection to the network is properly established
J1 - Serial Connection * for models without internal modem *
This connection provides for RS-232 connection for out-of-band connection to the switch. A terminal or modem can be
attached directly to this 9 pin connector. With a modem attached, connection is made using PPP (Dial-up-Networking) and
Telnet.
Connection directly to a laptop or terminal requires a null modem (crossover) cable.
With a terminal directly installed, a simple menu interface is used. These menus are identical to the telnet setup and control
screens. Use any terminal emulation software to connect to the switch.
Connection parameters are: 19200bps, 8 data bits, 1 stop bit, no parity (19200,8,n,1). Set flow control to OFF.
Page 3
Model iP-2815
2 NEMA 5-15 Linecords
8 NEMA 515 Outlets
J1-Serial J2-Network
Model iP-2815-M
2 NEMA 5-15 Linecords
8 NEMA 515 Outlets
J1-Phone Line* J2-Network
Model iP-2820
2 NEMA 5-15 Linecords
8 NEMA 515 Outlets
J1-Serial J2-Network
Model iP-2820-M
2 NEMA 5-20 Linecords
8 NEMA 515 Outlets
J1-Phone Line* J2-Network
Model iP-2810
2 IEC320 Inputs
8 IEC320 Outlets
J1-Serial J2-Network
Model iP-2810-M
2 IEC320 Inputs
8 IEC320 Outlets
J1-Phone Line* J2-Network
* RJ11 to D9 Adaptor
Item 1490149 Included
with all Modem models