4ms Company Listen Four Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 4ms Company Listen Four. 4ms Company Listen Four 7 pagina's. Four channel stereo mixer

Pagina afdrukken

Setting up your Listen Four

1. Power off your Eurorack system.

2. Connect the free end of the included power cable to a 16-pin Eurorack power header

on your power supply distribution system. The red stripe should match the white line

or -12V marking on the power distribution board. The other end of the power cable is

a 10-pin connector which should already be connected to the

red stripe on the power cable orientated towards the bottom of the module. Note:

Listen Four

The

is reverse-polarity protected, but incorrectly connecting any module

can damage any other on the power bus.

3. Using the included screws, securely attach the

4. Power on your Eurorack system.

Inputs

The

through a header on the back.

Level Knobs

All four channels have a

outputs. The

mute the channel (over -100dB of attenuation, typically).

Level 1

Channel Signal Lights

All four channels have a signal light which gets brighter as the signal gets louder. The color of

the light indicates the stereo content: blue displays the signal on the left channel, and green

displays the signal on the right channel. The signal light shows the signal post-fader (after the

Level knob). These lights are useful for determining which channels are active at any given

moment. However, they should not be used as precision indicators. For example, the green

lights will appear dimmer than the blue lights at low audio levels and brighter than the blue

lights at louder levels.

Channels 1 and 2: Panning

Channels 1 and 2 each have one input jack and a

signal. Turning the

fading it between the left and right outputs. The

Pan 1

position so you can find the center by feel.

Level 1

The panning curve has been carefully designed to achieve the perception of a sound source

being a consistent distance from the listener as it pans around.

Channels 3 and 4: Stereo inputs

Channels 3 and 4 each have left and right input jacks. Patching a stereo signal into these

jacks will accurately maintain the stereo image as the signal is mixed into the outputs. If you

patch a mono signal into the left jack and nothing into the right jack, the mono signal will

appear on both left and right outputs.

Channel 5: INS header

Level 3

See INS header section below

Main Outputs

Main Level Knob

The

is turned fully to the left, the outputs are muted. Turning the knob the to right increases the

volume. The maximum volume depends on the setting of the

Listen Four

has four input channels on the front. A fifth stereo channel can be accessed

Level

Listen Four

is very quiet, so turning the knob all the way down will completely

Pan

knob to the left or right will place the signal in the stereo field by

Main Level

knob controls the volume of the main left and right output jacks. When knob

Listen Four

to the rails of your case.

knob. This knob sets the volume which will appear on the

Pan

knob has a small detent in the center

Page

with the

knob. These channels accept a mono

Mod/Line

switch.