DV8 OE Plus Series Installatiehandleiding - Pagina 8
Blader online of download pdf Installatiehandleiding voor {categorie_naam} DV8 OE Plus Series. DV8 OE Plus Series 11 pagina's. Front bumper 2021 ford bronco
Pagina afdrukken
INSTALLATION
MANUAL
STEP
4
Using the provided M14 hardware,
22mm socket, and wrench, secure
the wings to the center section of the
bumper. Ensure the wings are aligned
with the face and top of the center
section of the bumper.
STEP
5
If vehicle is equipped with factory
sensors, lay out the harness over the
bumper and begin to feed the harness
into the bumper cavities so that the
sensors lay near their corresponding
holes.
Note: The large plug on the harness
needs to be on the driver side of the
bumper.
Note: If not equipped with sensors, use
provided sensor plugs.
STEP
6
Lean the bumper back and fit the
sensor bezels into place.
Note: Our bumpers are designed to accept
both factory metal bumper and plastic
bumper sensor bezels. All cutouts are cut
differently to ensure each bezel is placed
into the correct hole. They should easily
pop into place.
855-680-9595
NEED HELP?