DataStor DataSafe CN3310CX Installatiehandleiding - Pagina 2
Blader online of download pdf Installatiehandleiding voor {categorie_naam} DataStor DataSafe CN3310CX. DataStor DataSafe CN3310CX 2 pagina's. Scsi hard disk enclosure kit
Pagina afdrukkenInstalling The Hard Disk
Note: If you are not familiar with the location of ALL the listed
items, refer to hard disk user's guide / manufacturer
before continuing.
-
SCSI connector.
-
Power connector.
-
LED (Activity) light pins/port.
-
SCSI ID pins and pin #1.
Installing The Cables
1. If the SCSI ID Cable (Figure 6) has not been connected to the
SCSI ID Switch install it with the RED wire towards the bottom
(Figure 6).
2. Locate the SCSI ID Pins on your hard disk and connect the SCSI
ID cable to them (Figure 6). Make sure the RED wireconnects
to Pin #1 on the hard disk.
Note: If the wire colors differ from what is shown in Figure 6,
attach the SCSI ID cable to the SCSI ID switch with the
missing wire toward the top. Take the bottom wire and
follow it to the other side of the SCSI ID cable and connect
it to the hard disk SCSI ID Pin #1.
3. Locate the LED Light connector on your hard disk. Attach the
Black wire of the LED Light cable to the negative lead of the LED
Light connector and the White wire to the positive lead of the
LED Light connector.
Note: Many user's guides do not call out the negative and
positive leads of the LED Light connector on the hard
disk. If Disk Activity Light (Figure 3) is not operating,
simply reverse the connectios inside the hard disk
enclosure. This process will not cause damage.
4. Connect the SCSI cable and Power cable (Figure 5). The
connectors on both of these cables are "keyed" and will only
allow for proper installation.
Finishing The Installation
1. Mount the hard disk to the bottom of the enclosure using the four
(4) screws provided (Figure 5).
2. With the air vents towards the front, hold the cover in your left
hand. Hold the slide-out mounting tray with your right hand.
3. Slide mounting tray into the cover until the front of it snaps into
place against the cover.
4. Reattach rubber feet to the bottom side of the enclosure using
the screws removed in opening the enclosure (Figure 4).
Copyright 2000 by DataStor, Inc. All rights reserved. No part of this document may be reproduced in any form
without prior written consent from DataStor. The information and specifications in this document are subject to
change without notice. Changes to this document are incorporated in new versions.
DataStor, and the DataStor logo are reqistered trademarks of DataStor, Inc. Other trademarks used herein are the
property of their respective owners. This document was printed in the United States Of America.
Installation Guide - High Performance 3.5" SCSI Hard Disk Enclosure Kit - Rev 1.0 - Nov. 2000 - PN - CN3310CX - Page 2 of 2
Figure 5
Hard
Disk
SCSI ID
Cable
LED
Light
Cable
Figure 6
Black
SCSI ID
Cable
Orange
Blue
Yellow
SCSI Jumper Pins (On Hard Disk)
1
2
4
8
SCSI ID Cable Wire Color
Black
Red
Yellow
Blue
Orange
12601 Monarch Street
Garden Grove, CA 92841-3918
800-777-6621 Fax: 949-833-9600
Power
SCSI
Cable
Cable
16 Position
SCSI ID
Switch
Red (To Jumper Pin #1)
SCSI ID #
Ground Pin
1 - Signal Pin
2 - Signal Pin
4 - Signal Pin
8 - Signal Pin