Agri-Fab 45-02141 Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Agri-Fab 45-02141. Agri-Fab 45-02141 12 pagina's. Broadcast spreader 100 (push)
Ook voor Agri-Fab 45-02141: Gebruikershandleiding (13 pagina's)
Pagina afdrukken9.
Place the handle tube (long) on the crossover tube,
(side between crossover tube and hopper), align the
holes in the handle tube, crossover tube, and shaft
support. Assemble with 1/4" hex bolt, flat washer and
hex lock nut removed in the previous step. See figures
6 and 7. DO NOT TIGHTEN AT THIS TIME.
10. Assemble two handle braces to the inside of the
hopper frame, one each side, using two 1/4" x 1-1/2"
hex bolts and two 1/4" lock nuts. See figure 7. DO NOT
TIGHTEN AT THIS TIME.
11. Align the holes in the ends of the two handle braces
with the hole nearest the middle of the handle tube
assembly. Secure with a 1/4" x 1-1/2" hex bolt and 1/4"
lock nut. See figure 7.
12. Tighten all hex lock nuts and bolts, following same
sequence as assembled in the previous three steps.
See figure 7.
HANDLE TUBE (LONG)
HEX BOLT
1/4" x 1-1/2"
1/4"
LOCK
NUT
FLAT WASHER
1/4" HEX
LOCKNUT
FIGURE 7
13. Assemble the leg stand tube to the handle tube (long)
using two 1/4" x 1-1/2" hex bolts. Secure tightly with
two 1/4" hex lock nuts. See figure 8.
14. Place a vinyl cap over the end of the leg stand tube.
See figure 8.
HITCH
BRACE
HEX BOLT
1/4" x 1-1/2"
1/4" HEX
BOLT
CROSSOVER
TUBE
SHAFT SUPPORT
HANDLE TUBE (LONG)
1/4"
LOCK
NUT
VINYL CAP
FIGURE 8
15. Assemble the flow control link (the end with the small
hole) to the flow control arm using one 1/4" x 5/8" hex
bolt and one 1/4" lock nut. Do not over tighten. The
flow control link must pivot freely. See figure 9.
16. Place the vinyl grip on the flow control arm. See figure
9.
VINYL GRIP
FLOW CONTROL
LINK
1/4" HEX
LOCK NUT
SMALLEST HOLE
FIGURE 9
5
1/4" x 1-1/2"
HEX BOLTS
LEG STAND TUBE
FLOW
CONTROL
ARM
1/4" x 5/8"
HEX BOLT