Aussie Pumps D1310P4 Gebruiks- en onderhoudsinstructies - Pagina 12

Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Aussie Pumps D1310P4. Aussie Pumps D1310P4 20 pagina's. Hot water pressure washer

Pagina afdrukken

USING

THE CLEANER

CONTROL PANEL

A - On/off switch

B - Temperature regulator

STARTING THE CLEANER

1) Turn on the water supply tap (fig. 5A).

2) Connect the water cleaner to the mains electricity supply by

plugging the plug into the socket.

3) Start the cleaner by turning the selector switch to pos. I

(fig. 7A).

Warning

The high pressure water jet generates a reaction force in the

lance. Keep a firm grip on the lance handle.

4) Press the trigger on the gun and begin washing.

5) To operate the water cleaner with hot water,

rature regulator to the recommended washing values.

Warning

In water cleaners with the "Total Stop" system, the motor starts

and stops when the lever on the lance handle is actioned or

released.

Danger

Do not block the handle lever in the delivery position.

IMPORTANT!

To eliminate any impurities

or air bubbles from the wa-

ter circuit we advise starting

the cleaner for the first time

without the lance and letting

the water run out for a few

seconds.

Impurities could block the

nozzle and cause malfun-

ction (Fig. 8).

0 0 ° °

MAX

250° ° F F

6 5 6 5 ° ° C C

120° °C C

140° ° F F

FIG. 7

turn the tempe-

(fig. 7B).

FIG. 8

USING THE ACCESSORIES.

The high pressure washer has a nozzle with a flat angle jet for

cleaning large surfaces.

ROTARY HEAD (optional accessory)

The high pressure washer can be fitted with a head with rotary

nozzle to clean the most stubborn dirt.

Danger:

Aim the jet from a certain distance to avoid damage caused by

the high pressure.

Do not aim the jet at people, animals or electrical sockets.

STOPPING THE CLEANER

Switch off the burner by turning the pressure regulator to

pos. "0"

(fig. 7B).

2) Let the cleaner run with cold water only for at least 30 seconds

to cool down the boiler.

3) Stop the cleaner by turning the selector switch to pos. "0"

(fig. 7A).

4) Discharge the pressure from the H.P. hose by pressing the

trigger on the gun.

5) Disconnect the water cleaner from the mains electricity

supply via the Solenoid switch or by unplugging the plug from

the socket.

6) Turn off the water supply tap (fig. 5A).

Warning

- If the water cleaner is left, even temporarily, turn it off by using

the Solenoid switch or by unplugging the plug from the socket.

- Water cleaners with the "Total Stop" device should be consid-

ered as off when the Solenoid switch is in the "O" position or

the plug is unplugged from the socket.

- When the water cleaner is not used, close the safety device

on the handle.(fig. 9).

- Dry use of the water cleaner causes serious damage to pump

gaskets.

FIG. 9