Agri-Fab 45-0324 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Agri-Fab 45-0324. Agri-Fab 45-0324 12 pagina's. Atv mounted 125 lb. broadcast spreader
Ook voor Agri-Fab 45-0324: Gebruikershandleiding (13 pagina's)

Pagina afdrukken

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers

(2) 7/16" Wrenches

(2) 1/2" Wrenches

(2) 9/16" Wrenches

REMOVAL OF PARTS FROM CARTON

Remove all parts and hardware packages from the carton. Lay

out all parts and hardware and identify using the illustrations

on pages 2 and 3.

1. Turn the spreader upside down as shown in ﬁ gure 1.

2. Press the two plugs into the ends of the frame tube.

See ﬁ gure 1.

HINT: Use a block of wood to help press the plug down

into the end of the tubing.

3. Assemble the two angle brackets and two 1/4" nylock

nuts onto the ends of the longer bolts that are already

assemble to the frame tube. Do not tighten yet. See

ﬁ gure 1.

FIGURE 1

4. Fasten the deﬂ ector to the angle brackets using two 1/4"

x 3/4" hex bolts, 1/4" ﬂ at washers and 1/4" nylock nuts.

Allow the angle brackets to swivel so that the deﬂ ector

curves naturally between the angle brackets and then

tighten all nuts. See ﬁ gure 2.

1/4" NYLOCK

NUT

ANGLE

BRACKET

PLUG

DEFLECTOR

FIGURE 2

Position the spreader for adequate clearance if

the vehicle mufﬂ er discharges straight toward

the rear.

NOTE: The top of the hopper should be at least 30" above

the ground. The mounting holes shown in ﬁ gures 3 and 4

will make the top of the hopper even with the vehicle's rear

rack. If exhaust blows against spreader, a higher mounting

position may help.

IMPORTANT: Before proceeding, determine if the mounting

brackets, when attached directly to the spreader frame, will

ﬁ t onto the vehicle rack. If they need to be farther apart, use

the extension brackets in ﬁ gure 4.

If you are NOT using extension brackets:

5. Attach the R.H. mounting bracket to the frame tube

using two 5/16" x 2" hex bolts and 5/16" nylock nuts as

shown in ﬁ gure 3. Tighten. Repeat for the L.H. mounting

bracket.

5/16" x 1-2"

HEX BOLT

MOUNTING

BRACKET, R.H.

FIGURE 3

1/4" x 3/4"

HEX BOLT

1/4" FLAT

WASHER

1/4" NYLOCK

NUT

5/16" NYLOCK NUT