Agri-Fab 190-163-100 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Agri-Fab 190-163-100. Agri-Fab 190-163-100 16 pagina's. 42 heavy duty lawnsweeper

Pagina afdrukken

ASSEMBLY OF SWEEPER

TOOLS REQUIRED FOR ASSEMBLY

(1)

Pliers

(1)

Screwdriver

(1)

Hammer

(1)

Adjustable Wrench

(1)

9/16" Open End or Box End Wrench

(1)

7/16" Open End or Box End Wrench

(1)

1/2" Open End or Box End Wrench

(1)

3/8" Open End or Box End Wrench

Note: Right hand (R.H.) and left hand (L.H.) are determined

from the operators position while seated on the tractor.

1. Cut off the plastic tie holding the height adjustment tube

in place. See ﬁ gure 1.

2. Assemble the R.H. and L.H. hitch tubes to the sweeper

housing using four 5/16" x 1-3/4" hex bolts, 5/16" lock

washers and 5/16" hex nuts. Do not tighten yet. See

ﬁ gure 1.

5/16" HEX NUT

5/16" LOCK

WASHER

PLASTIC TIE

HITCH TUBE (L.H.)

FIGURE 1

3. Place the spacer bushing into the hole in the height ad-

justment strap. Place the strap with the bushing between

the hitch tubes, aligned with the rear hole. Fasten the

hitch tubes together, with the strap and bushing between

them, using two 5/16" x 3" hex bolts, 5/16" ﬂ at washers

(smaller), 5/16" lock

Do not tighten yet. See ﬁ gure 2.

5/16" x 1-3/4"

HEX BOLT

washers and 5/16" hex lock nuts.

5/16" x 3"

HEX BOLT

5/16" FLAT

WASHER

(SMALL)

5/16" LOCK

WASHER

5/16" HEX

LOCK NUT

FIGURE 2

If your tractor hitch has 10" to 13" ground clearance use

the instructions below to assemble the sweeper hitch

brackets. If your tractor hitch has less than 10" ground

clearance, go to page 6.

4. Assemble the bent hitch bracket on top and the straight

hitch bracket to the bottom of the hitch tubes. Fasten with

two 5/16" x 2-1/4" hex bolts and 5/16" hex lock nuts as

shown in ﬁ gure 3. The bolts should straddle the front

hitch tube bolt. Do not tighten yet.

5. At this time tighten the four bolts fastening the hitch

tubes to the sweeper housing. Next, tighten the two

bolts fastening the hitch tubes together. Finally, tighten

the two bolts fastening the hitch brackets to the hitch

tubes.

6. Assemble the hitch pin, two 3/4" spacers and the

hairpin cotter to the hitch brackets. See ﬁ gure 3.

5/16" x 2-1/4"

HEX BOLT

HITCH PIN

HITCH

BRACKET

3/4" SPACERS

HITCH BRACKET

(STRAIGHT)

1/8" HAIRPIN

COTTER

FIGURE 3

HEIGHT

ADJUSTMENT

STRAP

SPACER

BUSHING

1/8"

5/16" HEX LOCK NUT